HP 13-h210dx x2, 13t-h200 x2, 13-h211nr x2 manual Wlan module

Reverse this procedure to install the solid-state drive.

WLAN module

Description		Spare part number
For use on all tablet models:
Intel Dual Band Wireless-AC 7260	802.11 ac 2×2 WiFi + BT 4.0 Combo Adapter	710661-006
Intel Wireless-N 7260BN 802.11 b/g/n 2×2 WiFi + BT 4.0 Combo Adapter		717384-006
Intel Dual Band Wireless-AC 3160	802.11ac 1×1 WiFi + BT 4.0 Combo Adapter for use only on	710662-006
tablet models with model numbers f000 through f099

Before removing the WLAN module, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

4.Remove the back cover (see Back cover on page 38).

5.Remove the tablet battery (see Tablet battery on page 40).

Remove the WLAN module:

1.Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.

NOTE: The WLAN antenna cable labeled “1” connects to the WLAN module “Main” terminal labeled “1”. The WLAN antenna cable labeled “2” connects to the WLAN module “Aux” terminal labeled “2”.

2.Remove the Phillips PM2.0×3.0 screw (2) that secures the WLAN module to the system board. (The WLAN module tilts up.)

Removal and replacement procedures 45