HP 13t-h200 x2, 13-h211nr x2, 13-h210dx x2 manual Hard drive

Hard drive

Description	Spare part number
500-GB, 5400-rpm, SATA, 5.0-mm hard drive (does not include hard drive bracket, hard drive	737957-005
connector cable, or screws)

NOTE: The hard drive bracket, hard drive connector cable, and screws are included in the Hard

Drive Hardware Kit, spare part number 736884-001.

Before removing the hard drive, follow these steps:

1.Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet and keyboard base by unplugging the power cord from the tablet and keyboard base.

3.Disconnect the tablet from the keyboard base.

4.Remove the bottom cover (see Bottom cover on page 68).

5.Remove the keyboard base battery (see Keyboard base battery on page 70).

6.Remove the power connector board (see Power connector board on page 74).

Remove the hard drive:

1.Release the grounding tape (1) that secures the hard drive to the keyboard/top cover.

2.Remove the four Phillips PM2.0×3.0 screws (2) that secure the hard drive to the keyboard/ top cover.

76 Chapter 4 Removal and replacement preliminary requirements