HP 13t-h200 x2, 13-h211nr x2, 13-h210dx x2 manual Audio/USB board, Description Spare part number

Audio/USB board

Description	Spare part number
Audio/USB board (includes audio jack, memory card reader, and USB port)	736894-001
NOTE: The audio/USB board does not include the audio/USB board cable. The audio/USB
board cable is included in the Cable Kit, spare part number 736883-001. See Cable Kit
on page 23 for more Cable Kit spare part information.

Before removing the audio/USB board, follow these steps:

1.Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet and keyboard base by unplugging the power cord from the tablet and keyboard base.

3.Disconnect the tablet from the keyboard base.

4.Remove the bottom cover (see Bottom cover on page 68).

5.Remove the keyboard base battery (see Keyboard base battery on page 70).

Remove the audio/USB board:

1.Release the power connector board ZIF connector (1) to which the audio/USB board cable is attached, and then disconnect the audio/USB board cable from the power connector board.

2.Release the audio/USB board ZIF connector (2) to which the TouchPad cable is attached, and then disconnect the TouchPad cable from the audio/USB board.

3.Release the audio/USB board ZIF connector (3) to which the keyboard cable is attached, and then disconnect the keyboard cable from the audio/USB board.

4.Remove the four Phillips PM2.0×3.0 screws (4) that secure the audio/USB board to the keyboard/top cover.

5.Lift the left side of the audio/USB board, and then swing it up (5) and to the right until it rests upside down on the right side of the keyboard/top cover.

Removal and replacement procedures 73