HP 13t-h200 x2, 13-h211nr x2, 13-h210dx x2 manual Audio/power connector board

Audio/power connector board

Description	Spare part number
Audio/power connector board	736887-001
NOTE: The audio/power connector board does not include the audio/power connector board
cable. The audio/power connector board cable is included in the Cable Kit, spare part number
736883-001. See Cable Kit on page 23 for more Cable Kit spare part information.

Before removing the audio/power connector board, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

4.Remove the back cover (see Back cover on page 38).

5.Remove the tablet battery (see Tablet battery on page 40).

Remove the audio/power connector board:

1.Release the audio/power connector board ZIF connector (1) to which the NFC module cable is attached, and then disconnect the NFC module cable from the audio/power connector board.

2.Release the system board ZIF connector (2) to which the audio/power connector board cable is attached, and then disconnect the audio/power connector board cable from the system board.

3.Disconnect the speaker cable (3) from the audio/power connector board.

4.Remove the two Phillips PM2.0×3.0 screws (4) that secure the audio/power connector board to the display assembly.

Removal and replacement procedures 55