TouchPad
Description | Spare part number |
|
|
TouchPad (includes cable) | |
|
|
Before removing the TouchPad, follow these steps:
1.Turn off the tablet and keyboard base. If you are unsure whether the tablet and keyboard base are off or in Hibernation, turn the tablet on, and then shut it down through the operating system.
2.Disconnect the power from the tablet and keyboard base by unplugging the power cord from the tablet and keyboard base.
3.Disconnect the tablet from the keyboard base.
4.Remove the bottom cover (see Bottom cover on page 68).
5.Disconnect the keyboard base battery cable from the audio/USB board (see Keyboard base battery on page 70).
Remove the TouchPad:
1.Release the audio/USB board ZIF connector (1) to which the TouchPad cable is attached, and then disconnect the TouchPad cable from the audio/USB board.
2.Remove the six Phillips PM2.0×2.5 screws (2) that secure the TouchPad to the keyboard/ top cover.
3.Remove the TouchPad (3).
Reverse this procedure to install the TouchPad.
72 | Chapter 4 Removal and replacement preliminary requirements |