HP 13-h210dx x2, 13t-h200 x2, 13-h211nr x2 manual Docking connecter board

2.Release the vibrator module (2) from the clip molded into the display assembly.

3. Remove the vibrator module and cable. Reverse this procedure to install the vibrator module.

Docking connecter board

Description	Spare part number
Docking connecting board	736888-001
NOTE: The docking connector board does not include the docking connector board cables. The
docking connector board cables are included in the Cable Kit, spare part number 736883-001.
See Cable Kit on page 23 for more Cable Kit spare part information.

Before removing the docking connector board, follow these steps:

1.Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system.

2.Disconnect the power from the tablet by unplugging the power cord from the tablet.

3.Disconnect all external devices from the tablet.

4.Remove the back cover (see Back cover on page 38).

5.Remove the tablet battery (see Tablet battery on page 40).

Removal and replacement procedures 57