HP NetServer 5971-0821 manual Adpt160m.ham Command Line Options, Option Values Default Description

adpt160m.ham Command Line Options

Option	Values	Default	Description
auto_disable_tagq=	on, off	off	Enables/disables auto disable
			tagged queuing algorithm.
dev_enable=	0-FFFF	FFFF	Allows you to enable the driver's
			registration of SCSI devices on a
			per target basis. By default, all
			targets are scanned. A bit value
			of 0 causes the target not to
			register under the operating
			system. These devices are still
			accessible via ASPI. This enable
			bit mask is entered in hex (see
			“Bit Mask Options” on page 58).
flush_diskreq=	0-FFFF	0	A bit mask to send occasionally
			ordered tags to specific targets.
			By default, no targets receive
			occasionally ordered tags. This
			bit mask is entered in hex (see
			“Bit Mask Options” on page 58).
instr=	on, off	off	Enables/disables recording of I/O
			statistics.
lun_enable=a	0-FF	01	A bit mask to enable scanning for
			specific LUNs on all targets. The
			default value of 01 causes the
			driver to scan LUN 0 only. This
			enable bit mask is entered in hex
			(see “Bit Mask Options” on
			page 58.)
max_tags=	1-128	16	Specifies maximum number of
			tagged commands per device.

56