9.After removing the cartridges from the desired carriers, reinstall each carrier on the autoloader belt (see Figure 17).
—Make sure that the rollers on the bottom of the carrier are aligned in the carrier tracks.
—Make sure that the belt post beneath each carrier is inserted into the proper autoloader belt loop.
Note | There are unused loops on the belt. The proper belt loops have |
| an extra bump on the outside of the loop. See Figure 17. |
|
|
Figure 17 Installing the Carrier
10.Ensure the carrier is properly installed on the belt by gently pressing on the top of the carrier and sliding it back and forth. If it is properly attached to the belt, it should not move. If it does, reinstall the carrier.
11.Replace the top cover of the autoloader and reinstall the eleven cover screws and mounting brackets.
Chapter 4 | Diagnostics and Troubleshooting 65 |