Use the up/down arrows to scroll through the device’s settings. The current setting will be displayed on the right−hand side of the screen (figure 12). For example, current value: disabled. Press edit if you want to modify that setting, or press back to return to the previous screen.
Available settings for the devices depend on the installed components. Shown below is an example of enabling and changing the balance point control from default (Disabled) to Enabled. After selecting Enabled, press save to save the changes and return to the previous screen.
The returning screen may appear with the message in red 3, note that two additional items are listed in red. Use the arrows to scroll and highlight each item appearing in red. Press edit, make any desired changes, and press save.
When all affected settings have been edited/saved, the red message disappears. Press back to return to the o adjust a setting ..." screen.
If no more adjustments are necessary, press next to advance to the
run" screen (see Page 19).
System |
| Balance Point Control | |
|
| ||
Staged Delay Timers |
|
| |
2nd Stage Delay |
| current value | |
3rd Stage Delay |
| Disabled | |
Balance Point Control |
|
| |
Humiditrol Comfort Adjust |
| edit | |
Balance Point Control | |||
Select oneControl Mode |
|
| |
Min Dehumidification Setpoint |
| reset | |
OK/HumidDisabledBoundary | Enabled | ||
| |||
|
| back | |
save | cancel |
| |
System
Staged Delay Timers 2nd Stage Delay 3rd Stage Delay
Lock In 2nd stage HP by Outdoor Temp Balance Point Control
High Balance Point
Low Balance Point
Humiditrol Comfort Adjust
Humidification Control Mode
Min Dehumidification Setpoint
Balance Point Control |
|
current value |
|
Enabled |
|
please view and save all | edit |
red settings |
|
High Balance Point reset
Range is −17 to 75
Default is 0, inc:1
back
set−to
50
save cancel
Figure 12. Accessing device to modify | Figure 13. Modify device settings |
G71MPP or SLP98 Furnace Note:
If your icomfort
506920−01 09/12 | Page 14 |