Pentair 4/100, 4/160 important safety instructions EasyTouch to IntelliFlo 4 pin configuration

11

4.Lower down the hinged control panel to access the EasyTouch motherboard.

5.Route the communication cable into the lower plastic grommet, up through the low voltage raceway to the EasyTouch load center motherboard.

Control panel motherboard

Low voltage

Raceway

6.Strip back the cable conductors ¼ inch. Insert the two wires into the screw terminals on the board. Secure the wires with the screws.

7.EasyTouch to IntelliFlo 4 pin configuration:

•IntelliFlo: Connect pin 6 (green) to EasyTouch screw terminal pin 2 (green)

•IntelliFlo: Connect pin 7 (yellow) to EasyTouch screw terminal pin 3 (yellow)

EasyTouch (J20) screw terminal

EasyTouch

IntelliFlo

screw terminal

Pin 6

connector

(2-wire cable)

(Green)

2 (GRN)	GREEN (Pin 6)
3 (YEL)	YELLO (Pin 7)

Pin configuration

Pin 7 (Yellow)

IntelliFlo connector pin configuration

8.Insert the screw terminal onto the EasyTouch COM-PORT (J20) board connector. Note: Multiple wires may be inserted into a single screw terminal.

EasyTouch

COM-PORT (J20)

Indoor Control Panel

IntelliChlor

IntelliFlo

RF Transceiver

IntelliFlo 4 Installation and User’s Guide