13
Connecting IntelliFlo 4 to an IntelliTouch System
The IntelliFlo 4 can be controlled by an IntelliTouch system via the
(P/N 350122). In this configuration, IntelliTouch 4 starts, stops and controls the speed of the IntelliFlo 4 pump. When the IntelliTouch does this, it rewrites the IntelliFlo 4 memory, which can take several seconds. This causes a delay after a command is given on the IntelliTouch control panel until the Intelliflo 4 physically responds.
The IntelliFlo 4 control panel is disabled when communicating with the IntelliTouch system. Note that IntelliTouch will not start communicating with the IntelliFlo 4 until the appropriate pump address is assigned to a circuit. The IntelliFlo 4 default pump address is one. See page 6 for details about how to check the address and change if necessary. For more information, refer to the IntelliTouch User's Guide (P/N 520102).
To connect the IntelliFlo 4 communication cable to IntelliTouch load center:
1.
CAUTION - Switch the main power off to the IntelliTouch load center.
2.Unlatch the IntelliTouch load center front door spring latches, and open the front door.
3.Remove the
4.Loosen the two control panel access screws and fold down the outdoor control panel.
5.Insert the
Personality Board
Low voltage raceway
Plastic grommet
Access |
screw |
screw |
shown) |
IntelliTouch Load Center