20
Wiring the IntelliFlo 4
To connect the IntelliFlo 4 to an AC power source:
1.Make sure all electrical breakers and switches are turned off before wiring motor.
2.Make sure that the wiring voltage is 230 VAC.
3.Use #12 AWG for wire runs up to 100 feet and #10 AWG for lengths longer than 100 feet. When in doubt use a heavier gauge (larger diameter) wire. Heavier gauge will allow the motor to run cooler and moreefficient.
4.Make sure all electrical connections are clean and tight.
5.Cut the wires to the appropriate length so they do not overlap or touch when connected.
6.Permanently ground the motor using the green ground wire, as shown below. Use the correct wire size and type specified by National Electrical Code. Make sure the ground wire is connected to an electrical serviceground.
7.Bond the motor to the pool structure in accordance with the National Electrical Code. Use a solid No. 8 AWG or larger copper conductor. Run a wire from the external bonding lug to the pool bonding structure, as shown below.
8.The IntelliFlo pump is designed to be permanently connected to its power source. Typically the pump receives power directly from the circuit breaker. No contactor or motor starter is required. The drive controls the starting and stopping of the pump. If the IntelliFlo is connected to an automation system, such as EasyTouch or IntelliComm, the drive must be powered up to receive and respond to the
9.For wiring pinouts for the communications port, see page 11.
GROUND WIRE (GREEN)
IntelliFlo 4 wiring harness
Red = Hot
Red = Hot
Green/yellow stripe = Ground
BONDING LUG