Rinnai 24e user manual Important Information

Page 12

IMPORTANT INFORMATION

Excessively hot water is dangerous, especially for young children and the infirm. The water heater allows you to control the temperature of your hot water to safe levels.

DO

DO

NOT

Water temperature over 50ºC can cause severe burns instantly or even death from scalding.

Children, disabled and the elderly are at the highest risk of being scalded by excessively hot water.

Always test the temperature of the water before bathing or showering.

Burns from hot water taps can result in very severe injuries to young children.

Hot water at 65°C can severely burn a child in less than half a second. At 50°C it takes five minutes.

Burns can occur when children are exposed directly to hot water or when they are placed into a bath which is too hot.

Do stay with children

whenever they are in the bathroom.

Consider child—resistant taps

Do take them out of the bathroom if

or inexpensive tap covers,

you need to answer the phone or

both of which prevent a child’s

door.

hand from turning on the tap.

Do test the temperature of the water

Consider reducing the

with your elbow before placing your

temperature of the water

child in the bath.

supplied to the hot tap to

Do make sure that the tap is turned

500C.

 

off tightly.

This approach can be extremely

Do consider setting your Rinnai

valuable because it requires a

one time action for a long term

Infinity 16e at a maximum

reduction in risks of scalds.

temperature of 500C.

This type of automatic protection

Do install a child proof tap cover

is important during times when a

parent or carer has been

OR,

distracted.

 

Do install a child resistant tap.

 

Do not leave a toddler in the care of

 

another small child. The older child

 

may not have safely set the temperature.

 

12

Image 12
Contents Infinity 24e Rinnai UK Warranty Standard UseDefinition of Standard Use Definition of Commercial UseContents Unpacking Rinnai Water Heater Installation Instructions Important InformationInstallation Instructions Positioning Appliance LocationInstallation Instructions Connections Water SupplyWater Connection Gas ConnectionFlue Requirements Positioning Dimensions Technical Details Infinity 24eFeatures and Benefits Operating Noise Level is Very LOWImportant Information OFF Operation Without Remotes Turn On by opening the hot water tapTemperature Controls General Temperature Controls Installation Universal Temperature ControllerConnecting One or Two Controllers Connecting Three ControllersConnecting Four Controllers Temperature Controls Temperature Controls Operating Using 1 Universal Temperature Controller Adjusting TemperatureUsing 2 or more Universal Temperature Controllers Switching the system onUsing hot water Bathroom temperatures should be no more than 500CUsing 4 Universal Temperature Controllers StepUsing High Temperature Display Controllers Additional safety features To turn off your hot water systemTemperature Controls Information Testing GAS Pressure Setting Mbar Propane 1.7 mbarPropane Mbar DIP Switch Setting Dip Switch Positions ExplainedDip Switches Explained Temperatures Remotes Connected Error Messages Code Fault Remedy DisplayedInstallations with circulation pumps With temperature controller fittedWithout temperature controller fitted Restarting the Rinnai Water Heater Standard systemWiring Diagram Diagnostic Points Specification Electrical Supply…………………………….…………..……………….230V AC 50Hz 1phPage Service Contact Commissioning Check List