Rinnai 24e user manual Off

Page 13

IMPORTANT INFORMATION

Always check water temperature before

Hot water may go out without warning at

use.

low water flows.

OFF

Refer to warning about hot water on

 

page 12 for important safety information.

 

 

 

The Infinity 24e controls the water

If freezing temperatures

temperature automatically. For high

are expected, turn off the

temperatures it may reduce the flow. The

water and gas, and

water from the hot tap may be reduced

drain the water

after the temperature shown on the

heater.

remote control is raised. The water flow

 

may also vary with the temperature of the

1. Water Off

incoming water supply.

2. Gas Off

 

 

3. Drain Water

 

If the power is left on the

 

Automatic Frost Protection

 

will prevent the unit from

 

Freezing. Frost protection

 

is standard on the external

 

units.

 

 

Keep flammable materials, trees, shrubs,

Do not touch the unit cover or the flue

chemicals etc. away from the heater.

outlet. Do not insert objects into the flue

 

outlet.

On cold days steam may be discharged from the flue outlet. This is normal, do not be alarmed. It does not indicate a fault.

13

Image 13
Contents Infinity 24e Standard Use Rinnai UK WarrantyDefinition of Standard Use Definition of Commercial UseContents Unpacking Rinnai Water Heater Important Information Installation InstructionsAppliance Location Installation Instructions PositioningWater Supply Installation Instructions ConnectionsWater Connection Gas ConnectionFlue Requirements Positioning Dimensions Infinity 24e Technical DetailsOperating Noise Level is Very LOW Features and BenefitsImportant Information OFF Turn On by opening the hot water tap Operation Without RemotesTemperature Controls General Universal Temperature Controller Temperature Controls InstallationConnecting Three Controllers Connecting One or Two ControllersConnecting Four Controllers Temperature Controls Temperature Controls Operating Adjusting Temperature Using 1 Universal Temperature ControllerSwitching the system on Using 2 or more Universal Temperature ControllersUsing hot water Bathroom temperatures should be no more than 500CStep Using 4 Universal Temperature ControllersUsing High Temperature Display Controllers To turn off your hot water system Additional safety featuresTemperature Controls Information Testing GAS Pressure Setting Propane 1.7 mbar MbarPropane Mbar Dip Switch Positions Explained DIP Switch SettingDip Switches Explained Temperatures Remotes Connected Code Fault Remedy Displayed Error MessagesWith temperature controller fitted Installations with circulation pumpsWithout temperature controller fitted Standard system Restarting the Rinnai Water HeaterWiring Diagram Diagnostic Points Electrical Supply…………………………….…………..……………….230V AC 50Hz 1ph SpecificationPage Service Contact Commissioning Check List