Rinnai 24e user manual Using 2 or more Universal Temperature Controllers, Switching the system on

Page 21

TEMPERATURE CONTROLS - OPERATING

Using 2 or more Universal Temperature Controllers.

Switching the system ON.

The hot water system and all controllers can be switched ON and OFF from any controller by pressing the On/Off button as shown. When the system is turned ON the water temperature display will be lit.

During normal operation the system is left ON. Do not push the On/Off button when water is running.

Using hot water.

Ensure the system is switched On by verifying the temperature display is lit. Ensure the controller has priority by verifying the Transfer LED indicator is lit. If it is not then press the Transfer button once. This gives the local controller priority of temperature over the system.

Select the desired temperature using the Hot water temp. buttons. The selected temperature will be displayed on all controller displays. This is the water temperature which will be supplied from the heater.

Bathroom temperatures should be no more than 500C.

Open the hot water tap. The appliance will be activated and the In Use indicator will be lit.

21

Image 21

Contents Infinity 24e Standard Use Rinnai UK WarrantyDefinition of Standard Use Definition of Commercial UseContents Unpacking Rinnai Water Heater Important Information Installation InstructionsAppliance Location Installation Instructions PositioningWater Supply Installation Instructions ConnectionsWater Connection Gas ConnectionFlue Requirements Positioning Dimensions Infinity 24e Technical DetailsOperating Noise Level is Very LOW Features and BenefitsImportant Information OFF Turn On by opening the hot water tap Operation Without RemotesTemperature Controls General Universal Temperature Controller Temperature Controls InstallationConnecting One or Two Controllers Connecting Three ControllersConnecting Four Controllers Temperature Controls Temperature Controls Operating Adjusting Temperature Using 1 Universal Temperature ControllerSwitching the system on Using 2 or more Universal Temperature ControllersUsing hot water Bathroom temperatures should be no more than 500CStep Using 4 Universal Temperature ControllersUsing High Temperature Display Controllers To turn off your hot water system Additional safety featuresTemperature Controls Information Testing GAS Pressure Setting Mbar Propane 1.7 mbarPropane Mbar DIP Switch Setting Dip Switch Positions ExplainedDip Switches Explained Temperatures Remotes Connected Code Fault Remedy Displayed Error MessagesInstallations with circulation pumps With temperature controller fittedWithout temperature controller fitted Standard system Restarting the Rinnai Water HeaterWiring Diagram Diagnostic Points Electrical Supply…………………………….…………..……………….230V AC 50Hz 1ph SpecificationPage Service Contact Commissioning Check List