Rinnai 24e user manual Installation Instructions, Important Information

Page 5

INSTALLATION INSTRUCTIONS

IMPORTANT INFORMATION

1.Gas safety (Installation & Use) regulations 1998 are the ‘Rules in force’. In your own interest and that of safety, it is law that all gas appliances are installed by competent persons in accordance with the above regulations. Failure to install appliances correctly could lead to prosecution. Other persons should NOT attempt to install this equipment.

2.Unpack the appliance and check it carefully. If it appears to have any defects or damage DO NOT INSTALL, contact your supplier.

3.This appliance is for normal hot water supply only and should not be used as pool or spa water heater.

4.The heater must be installed in the vertical position with the gas and water connections on the underside pointing vertically downward.

5.Installation must be carried out in accordance with the current issue of the following:

Building regulations issued by the Department of the Environment and Building Standards (Scotland) Regulations.

I.E.E. Wiring regulations for electrical installations.

Gas safety (Installation and Use) Regulations current issue. BS 5546

BS 5440 BS 6891 BS 5482 BS 6700 Local byelaws Water regulations

Health and safety at work etc. Act 1974

Such other specifications and regulations that may supersede or complement the above documents.

Please be sure that you are fully aware of your obligations and responsibilities under these regulations.

5

Image 5
Contents Infinity 24e Standard Use Rinnai UK WarrantyDefinition of Standard Use Definition of Commercial UseContents Unpacking Rinnai Water Heater Important Information Installation InstructionsAppliance Location Installation Instructions PositioningWater Supply Installation Instructions ConnectionsWater Connection Gas ConnectionFlue Requirements Positioning Dimensions Infinity 24e Technical DetailsOperating Noise Level is Very LOW Features and BenefitsImportant Information OFF Turn On by opening the hot water tap Operation Without RemotesTemperature Controls General Universal Temperature Controller Temperature Controls InstallationConnecting Four Controllers Connecting One or Two ControllersConnecting Three Controllers Temperature Controls Temperature Controls Operating Adjusting Temperature Using 1 Universal Temperature ControllerSwitching the system on Using 2 or more Universal Temperature ControllersUsing hot water Bathroom temperatures should be no more than 500CStep Using 4 Universal Temperature ControllersUsing High Temperature Display Controllers To turn off your hot water system Additional safety featuresTemperature Controls Information Testing GAS Pressure Setting Propane Mbar MbarPropane 1.7 mbar Dip Switches Explained DIP Switch SettingDip Switch Positions Explained Temperatures Remotes Connected Code Fault Remedy Displayed Error MessagesWithout temperature controller fitted Installations with circulation pumpsWith temperature controller fitted Standard system Restarting the Rinnai Water HeaterWiring Diagram Diagnostic Points Electrical Supply…………………………….…………..……………….230V AC 50Hz 1ph SpecificationPage Service Contact Commissioning Check List