Rinnai 24e user manual Propane 1.7 mbar, Propane Mbar

Page 28

GAS PRESSURE SETTING

11.Remove rubber access plug and adjust the regulator screw on the modulating valve (fig. 4 and 4a) as required to the pressure below.

N.G

0.8 mbar

 

 

Propane 1.7 mbar

12.Lock the regulating screw on the modulating valve.

13.Set the appliance to 'Forced High' combustion by setting both no. 2 and no. 3 dipswitches of the bottom set of switches (SW2) to 'ON'.

(fig.5) Ensure maximum water flow.

14.Check the burner test point pressure.

15.Adjust the high pressure potentiometer on the Printed Circuit Board below SW2 (fig. 6) to the pressure shown below. The potentiometer is very sensitive, turn no more than a few de- grees at a time; then let the pressure settle down before turning it more.

N.G

9.0 mbar

 

 

Propane

22.6 mbar

 

 

16.IMPORTANT: Set dip switch no. 2 and no. 3 on the bottom set of switches (SW2) to 'OFF' to return the appliance to 'Normal' combustion. (fig. 7)

17.Close hot water tap.

18.Turn OFF the gas supply and 230V power supply.

19.Remove pressure gauge, and replace sealing screw.

20.Turn 'ON' the gas supply and 230V power supply.

21.Operate unit and check for gas leaks at test point.

22.Replace the front cover of the appliance.

28

(fig 4a)

Forced High

off on SW2 1

2

3

(fig 5)

(fig 6)

Normal

off on SW2 1 2

3

(fig 7)

CAUTION

Image 28
Contents Infinity 24e Rinnai UK Warranty Standard UseDefinition of Standard Use Definition of Commercial UseContents Unpacking Rinnai Water Heater Installation Instructions Important InformationInstallation Instructions Positioning Appliance LocationInstallation Instructions Connections Water SupplyWater Connection Gas ConnectionFlue Requirements Positioning Dimensions Technical Details Infinity 24eFeatures and Benefits Operating Noise Level is Very LOWImportant Information OFF Operation Without Remotes Turn On by opening the hot water tapTemperature Controls General Temperature Controls Installation Universal Temperature ControllerConnecting Three Controllers Connecting One or Two ControllersConnecting Four Controllers Temperature Controls Temperature Controls Operating Using 1 Universal Temperature Controller Adjusting TemperatureUsing 2 or more Universal Temperature Controllers Switching the system onUsing hot water Bathroom temperatures should be no more than 500CUsing 4 Universal Temperature Controllers StepUsing High Temperature Display Controllers Additional safety features To turn off your hot water systemTemperature Controls Information Testing GAS Pressure Setting Propane 1.7 mbar MbarPropane Mbar Dip Switch Positions Explained DIP Switch SettingDip Switches Explained Temperatures Remotes Connected Error Messages Code Fault Remedy DisplayedWith temperature controller fitted Installations with circulation pumpsWithout temperature controller fitted Restarting the Rinnai Water Heater Standard systemWiring Diagram Diagnostic Points Specification Electrical Supply…………………………….…………..……………….230V AC 50Hz 1phPage Service Contact Commissioning Check List