Schneider Electric iEM3200, iEM3300 Meter status information, Device clock, Date/time format

iEM3100 / iEM3200 / iEM3300 series user manual Front panel display and meter setup

Meter status information

Two LEDs on the front panel indicate the current status of the device: the green status LED and the yellow energy pulsing LED.

The icons in the table below indicate the LED state as follows:

• = LED is off

• = LED is on

• = LED is flashing

Status LED Energy pulsing LED Description

1s >

Related topics

Off

On, no pulse counting

On, with pulse counting

Error, pulse counting stopped

Abnormal, with pulse counting

See the section for the protocol of your device for information on the communication LED:

•“Troubleshooting” on page 103

•“Communications LED indicator for Modbus devices” on page 51

•“LED indicators for LonWorks meters” on page 63

•“Communications LED indicator for M-Bus meters” on page 76

•“Communications via BACnet” on page 89

The device clock

This section does not apply to the iEM3100, iEM3200 or iEM3300.

You must reset the time to account for any time change (for example, to switch the time from standard time to daylight savings time).

Clock behavior on power interruption

iEM3110, iEM3150, iEM3210, iEM3250, iEM3310 and iEM3350: When power is interrupted, the date and time are reset. When power is restored, the device automatically displays the screen to set Date and Time.

iEM3115, iEM3135, iEM3155, iEM3165, iEM3175, iEM3215, iEM3235, iEM3255, iEM3265, iEM3275, iEM3335, iEM3355, iEM3365 and iEM3375: When the power is interrupted, the device retains its date and time information for 3 days. If power is interrupted for longer than 3 days, the device automatically displays the screen to set Date and Time when power is restored.

Date/time format

The date is displayed in the following format: DD-MMM-YYYY.

The time is displayed using the 24-hour clock in the following format: hh:mm:ss.

DOCA0005EN-04 37