Schneider Electric iEM3100, iEM3300, iEM3200 Power system inputs iEM32 meters, Inputs and outputs

SpecificationsiEM3100 / iEM3200 / iEM3300 series user manual

Power system inputs: iEM32•• meters

	Characteristic	Value
	Measured voltage	Wye: 100 - 277 V L-N, 173 - 480 V L-L ±20%
		Delta: 173 - 480 V L-L ±20%
	Overload	332 V L-N or 575 V L-L
	Impedance	3 MΩ
	Frequency	50 / 60 Hz ±10%
Voltage inputs	Measurement category	III
	Minimum wire temperature rating required	90 °C (194 °F)
	Maximum device consumption	< 10 VA
	Wire	2.5 mm2 / 14 AWG
	Wire strip length	8 mm / 0.31 in
	Torque	0.5 Nm / 4.4 in•lb
	Nominal current	1 A or 5 A
	Measured current	20 mA to 6 A
	Withstand	10 A continuous, 20 A at 10 sec/hr
	Minimum wire temperature rating required	90 °C (194 °F)
Current inputs	Impedance	< 1 mΩ
	Frequency	50 / 60 Hz ±10%
	Burden	< 0.036 VA at 6 A
	Wire	6 mm2 / 10 AWG
	Wire strip length	8 mm / 0.31 in
	Torque	0.8 Nm / 7.0 in•lb
Inputs and outputs

Characteristic		Value	Meters
	Number	1
	Type	Form A
	Load voltage	5 – 40 V DC
Programmable digital	Maximum load current	50 mA	iEM3135 / iEM3155 / iEM3165 /
	Output resistance	0.1 – 50 Ω	iEM3235/ iEM3255 / iEM3265 /
output			iEM3335 / iEM3355 / iEM3365
	Isolation	3.75 kV rms
	Wire	1.5 mm2 / 16 AWG
	Wire strip length	6 mm / 0.23 in
	Torque	0.5 Nm / 4.4 in•lb
	Number	1
	Type	S0 form (IEC 62053-31 compatible)
	Pulses / kWh	Configurable
	Voltage	5 – 30 V DC
	Current	1 – 15 mA
Pulse output			iEM3110 / iEM3210 / iEM3310
	Pulse width	Configurable
		Minimum width is 50 ms
	Isolation	3.75 kV rms
	Wire	2.5 mm2 / 14 AWG
	Wire strip length	7 mm / 0.28 in
	Torque	0.5 Nm / 4.4 in•lb

98 DOCA0005EN-04