In case of contemporaneous signalling of both filters, LEDs L1 and L2 flash jointly. To reset, carry out the procedure described above for 2 times.
The first time it resets the charcoal filter signal, the second time it resets the grease filter signal.
The charcoal filter signal is not active in the standard mode.
In case the hood is used in filter version it is necessary to enable the charcoal filter signal.
Activating charcoal filter signal:
Set the hood to OFF and press T2+T3 button for 3”. Once the button has been pressed, LED L1 flashes for 1".
LEDs L1 and L2 flash until the hood gives out a "BEEP", as confirmed activation, and goes back to OFF.
Deactivating charcoal filter signal:
Set the hood to OFF and press T2+T3 button for 3”.
Once the buttons have been pressed, the LEDs L1+L2 flashes for 1". The hood gives out a "BEEP" and LED L2 switches off.
LED L1 flash until the hood gives out a "BEEP", as confirmed disactivation, and goes back to OFF.
27