Ultimate Products UP-206 manual Part 6a U Series

Page 22

20

Part 5:

Testing Operator and Control Box

Note: Every Step must be completed before connecting the signal-sending devices.

A. Plug the control box into 110V AC outlet.

B. Pull up black knob on top of Regulator. Turn knob clockwise to increase air pressure. (See below)

Note: Recommended pressure varies between 60-100 PSI

C. Press open or close on the control box to begin operating the door.

Note: If door operates opposite of what controls indicate, Turn air pressure off at regulator and reverse the two air lines at cylinders.

Part 6a: U Series

Door speed adjustments and fine tuning

Note: Only for U Series operators

A. Door slows down too soon when opening.

Step 1- Locate the speed control valves at the top of the operator. The speed control valve farthest from the wall controls up.

( See below )

Down

UP

Step 2- With a small flat head screw driver, turn thread post on speed control valve ¼ turn counter clockwise. Open the door to see if door has desired cushioning. Repeat this step until satisfied with setting. Lock setting into place with nut around threaded post.

( See below )

Image 22

Contents  Necessary tools Supplies needed but not included with this kitPart 1BELT Installation Installing Tensioner Kit Before installing the air cylinder, Installing Tensioner Kit As shown on From belt before installing belt onto Operator Hanging Operator Page Page Setting Open and Close Door Limits Completed Operator set up view Installation Chain Drive Part 2INSTALLING Chain Drive Step Installing Chain Speed Control Kit Sprocket Assembly Part No. SPK1000 Step Completed Chain Operator set up, see Part Installing Air Lines Part 6a U Series Part 6b S Series Door adjustments and fine tuning Troubleshooting Install Signal SendersFixing Door or Operator Problems Fixing Control Problems Door cable is jumping Automatic Oiler Adjustment Cable JumpingCable jumping solutions Putting the cable back on the drum2624 Model DC Model DC Model DC Home of the Best Buy Guarantee Photo Amplifier Wiring Directions Limit Switch Wiring and Mounting Suggested Installation of Magnetic Loop Wiring Diagram Finder Timer to Control Box Operator with Belt Operator with Chain Ring AP1004 Check ball Control Box Power SupplyDimensions ModelOperators Operators with chains Superior or Economy Air-Powered OperatorsUltimate Air-Powered Operator Operators with beltsOperators with Automatic Oilers Cylinder OilingOperators without Oiler Tools and materials needed Items included in the kitCup Seals Breather Vents and Check Ball Piston Rod SealsNeedle Valve Page Technical assistance and salespeople are available Monday