Ultimate Products UP-206 manual Step

Page 18

16

Step 6

Attach operator to vertical track after it is aligned with sprocket and operator hangs straight down using self- taping screws. See Figure K. Tighten chain with turnbuckle. After chain is tight, lock turnbuckle into place with ½” nut on threaded rod. See Figure L. Slide one enclosed clamp assembly Part No. AP1055 so that ¾” of the rod extends above the clamp assembly as shown in Figure M. Tighten all bolts.

Image 18

Contents  Necessary tools Supplies needed but not included with this kitPart 1BELT Installation Installing Tensioner Kit Before installing the air cylinder, Installing Tensioner Kit As shown on From belt before installing belt onto Operator Hanging Operator Page Page Setting Open and Close Door Limits Completed Operator set up view Installation Chain Drive Part 2INSTALLING Chain Drive Step Installing Chain Speed Control Kit Sprocket Assembly Part No. SPK1000 Step Completed Chain Operator set up, see Part Installing Air Lines Part 6a U Series Part 6b S Series Door adjustments and fine tuning Install Signal Senders TroubleshootingFixing Door or Operator Problems Fixing Control Problems Door cable is jumping Automatic Oiler Adjustment Cable JumpingCable jumping solutions Putting the cable back on the drum2624 Model DC Model DC Model DC Home of the Best Buy Guarantee Photo Amplifier Wiring Directions Limit Switch Wiring and Mounting Suggested Installation of Magnetic Loop Wiring Diagram Finder Timer to Control Box Operator with Belt Operator with Chain Ring AP1004 Check ball Control Box Power SupplyDimensions ModelOperators Operators with chains Superior or Economy Air-Powered OperatorsUltimate Air-Powered Operator Operators with beltsCylinder Oiling Operators with Automatic OilersOperators without Oiler Items included in the kit Tools and materials neededCup Seals Piston Rod Seals Breather Vents and Check BallNeedle Valve Page Technical assistance and salespeople are available Monday