Ultimate Products UP-206 manual As shown on

4

Step 3

Install speed control kit to the operator. (Part No. TC2002).

Speed Control Kit (Part No. TC2002)

Installing Speed Control Kit

Before installing the speed control kit to the operator, place the operator flat on floor with the red plugs facing up. Remove red plugs from the air powered operator.Insert brass elbows (Part No. AP1080B) into

ports of both cylinders where red plugs were removed.

Tighten elbows slightly with 9/16 open-end wrench. Attach speed control valve at top of operator bracket with (2) two each 10x24x3/8 machine screws.

As shown on Page 5

After installing valves stretch air lines from top to bottom elbows, cutting air lines ¾” longer than bottom elbow. Attach air lines as shown.

See next page for Larger Image