Ultimate Products UP-206 manual Installing Tensioner Kit

Page 5

3

Installing Tensioner Kit

Insert one end of the tensioner rod with holes into round hole of the track bracket.

Place 1 washer on each side of bracket and add cotter pins (Part No. DF330).

Place tensioner roller on rod (as shown). End support bracket will be installed after hanging the operator. Proceed to Step 3.

Image 5

Contents  Supplies needed but not included with this kit Necessary toolsPart 1BELT Installation Installing Tensioner Kit Before installing the air cylinder, Installing Tensioner Kit As shown on From belt before installing belt onto Operator Hanging Operator Page Page Setting Open and Close Door Limits Completed Operator set up view Installation Chain Drive Part 2INSTALLING Chain Drive Step Installing Chain Speed Control Kit Sprocket Assembly Part No. SPK1000 Step Completed Chain Operator set up, see Part Installing Air Lines Part 6a U Series Part 6b S Series Door adjustments and fine tuning Fixing Door or Operator Problems Install Signal SendersTroubleshooting Fixing Control Problems Cable jumping solutions Automatic Oiler Adjustment Cable JumpingDoor cable is jumping Putting the cable back on the drum2624 Model DC Model DC Model DC Home of the Best Buy Guarantee Photo Amplifier Wiring Directions Limit Switch Wiring and Mounting Suggested Installation of Magnetic Loop Wiring Diagram Finder Timer to Control Box Operator with Belt Operator with Chain Ring AP1004 Check ball Dimensions Power SupplyControl Box ModelOperators Ultimate Air-Powered Operator Superior or Economy Air-Powered OperatorsOperators with chains Operators with beltsOperators without Oiler Cylinder OilingOperators with Automatic Oilers Cup Seals Items included in the kitTools and materials needed Needle Valve Piston Rod SealsBreather Vents and Check Ball Page Technical assistance and salespeople are available Monday