Samsung AS24VBFNUMG Connecting the assembly cable, Cable specification, Connecting the cable

2. Fix the indoor unit.

If you fix the indoor unit on a wall

(1) Fix the installation plate to the wall giving attention to the weight of the indoor unit.

		• If you mount the plate to a concrete wall using plastic anchors, make sure that		Plastic
		gaps between the wall and the plate, created by projected anchor, is less than		Anchor
		20mm.				Wall
					<20mm
If you fix the indoor unit on a window frame			If you fix the indoor unit on a gypsum board
(1) Determine the positions of the wooden uprights to be
	attached to the window frame.		(1) Use stud finder to find out locations of the studs.
(2) Attach the wooden uprights to the window frame giving
			(2) Fix the plate hanger on two studs.
	attention to the weight of the indoor unit.

(3)Attach the installation plate to the wooden upright using tapping screws.

• Search for other spots if there are less than two studs, or the distance between the studs are different from the plate hanger.

• Fix the installation plate without inclining to one side.

• Make sure that a wall can withstand the weight of the product. If you install the product in a place where it is not

strong enough to withstand the product weight, the unit could fall and cause injury.

Connecting the assembly cable

Cable specification

Model	Power cable	Interconnection cable	Type GL
09/12	3G, 1.0mm² H07RN-F	5G, 1.0mm² H07RN-F (AQ**)	20A
		3G, 1.0mm² H07RN-F (AS**)
18	3G, 2.5mm² H07RN-F	2G, 0.75mm² H05RN-F(AQ**)
		3G, 2.5mm² H07RN-F(AQ/AS**)
		3G, 2.5mm² H07RN-F (AQ/AS**)	25A
24	3G, 2.5mm² H07RN-F	3G, 0.75mm² H05RN-F (AQ**)
		1G, 0.75mm² H05RN-F (AS**)

• Connect the power cable to the auxiliary circuit breaker. If every pole fails to connect to

the power supply, it must be incorporated in a wire with a contact opening of ≥3mm.

Connecting the cable

Electrical work

1)For electrical and earth works, comply with the ‘technical standards of electrical installations’ and the the ‘wiring regulations’ of the Electricity Enterprises Act.

2)Tighten the terminal block screw to under 12kgf.cm.

3)Precautions when connecting terminal blocks of the indoor unit

Before connecting, make sure the connecting part of the terminal socket is facing upwards.

ENGLISH

Upside down	The terminal socket	There is no ring terminal
	is damaged.	to cover the wire.

There must be no space between the terminal and the screw when connected.

The terminal socket

is upside down. or there is a space between the screw and the ring terminal.

• For the terminal block wiring, use a wire with a ring terminal socket only.

CAUTION ng work.

31

UMG_AQ&AS18V@_IBIM_34038A_E--P14�P18���������.indd 31

2013-3-18 11:00:17