MAKING MINOR ADJUSTMENTS | SETTING UP THE |
TO THE DOORS | REFRIGERATOR |
Remember, a level refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on levelling the refrigerator.
Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational. If not, fi rst check the power supply and electricity source or try the troubleshooting section at the back of this user guide. If you have any further questions, contact your Samsung Electronics call center.
01 SETTING
Adjustment part
For minor adjustments the process is the same as detailed above. Open the doors and adjust them, one at a time, as follows:
3 Wrench
2 Bolt
1 Nut
1.Unscrew the nut 1 from the lower hinge until it reaches the upper end of the bolt 2 .
When you release the nut 1 , make sure that you use the Allen wrench provided 3
to loosen the bolt 2 in a
2.Adjust the height difference between the doors
by turning the bolt 2 clockwise 
or
counter clockwise 
.
When you turn clockwise 
, the door will move up.
3.After adjusting the doors, turn the nut 1
clockwise 
until it reaches the lower end of the bolt, then tighten the bolt again with the
wrench 3 to fi x the nut in place 1 .
If you do not secure the nut fi rmly, the bolt may release.
1.Place the refrigerator in an appropriate location with reasonable clearance between the wall and the refrigerator. Refer to installation instructions in this manual.
2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the temperature control to the coldest temperature and wait for an hour.
The freezer should get slightly chilled and the motor should run smoothly.
4.After powering the refrigerator, it will take a few hours to reach the appropriate temperature. Once the refrigerator temperature is suffi ciently cool, you can store food and drink in the refrigerator.
UP
setting up _9
2011.7.11 11:56:48 AM