Samsung ASV13PSPNXEA, ASV18PSPXXEA, ASV18PUQNXEA, ASV10PUQNXEA manual Using the Quiet function

Page 16

Using the Quiet function

You can reduce the noise generated from an indoor unit.

Press the Quiet button on the remote controller while the air conditioner is operating in Cool/Heat mode.

 Quiet indicator appears on the remote controller display.  The indoor unit will operate more quietly.

Cancel Press the Quiet button once again.

• If using a multi system, this function will work only when the Quiet function is set on all operated indoor units.

Using the Auto Clean function

Auto clean function will prevent from growing mold by eliminating the moisture inside of the indoor unit. Your indoor unit evaporates the moisture inside of the unit. Activate this function to provide you with more clean and healthier air.

Press the Auto Clean button.

 The Auto clean indicator on the indoor unit display appears and the Auto cleaning function runs.

When the air conditioner is turned on,

 The Auto clean indicator on the indoor unit display appears and the Auto cleaning function runs after stopping the air conditioner operation.

Auto Cleaning time can vary, depending on the previously used mode.

Auto(cool), Cool, Dry mode : approximately 30 minutes.

Auto(heat), Heat, Fan mode : approximately 15 minutes.

Cancel Press the Auto Clean button once again.

• When the air conditioner is turned on, the Auto clean function runs after stopping the air conditioner operation.

16

Image 16

Contents Air Conditioner Contents Safety precautions Important safety symbols and precautionsFollow directions Wall socketFor Using For Cleaning Checking before use Operation rangesPower button Checking the name of the partsMain parts DisplayChecking the remote controller Remote controller buttonsRemote controller display Battery changing timeStoring the remote controller Inserting the batteriesBasic function Button to adjust the temperature PressUsing the Turbo function Press the Air swing button on the remote controllerCirculate the air Position you preferMode Press the Set/Cancel button to active it on Press the button Press the button to set the timeUsing the Smart Saver function Timer 1 hourTimer 5 hours From the moment you have set the timerUsing the Quiet function Cleaning the indoor unit Cleaning the outdoor unit heat exchangerOpening the panel Heat exchangerCleaning the air conditioner Clean the AirSlide it down Dry the Ai lter in a ventilated areaMaintaining the air conditioner Periodical checksTroubleshooting If may not be a Outdoor unit Heat exchanger during Heat mode in winterConnection General information Model Name Included Models RemarkChoosing the installation location Installing the unitPower supply line, fuse or circuit breaker Won’t be considered in-warranty and charged to end userOutdoor Unit Model When the air outlet is towards the wall When installing more than 1 outdoor unitTop view Side view Accessories in the indoor unit case AccessoriesAccessories in the outdoor unit case Fixing the installation plate Optional accessoriesTools required for installation General Tools Tools for test operationsConnecting the cable Connecting the assembly cableFix the indoor unit Extend the assembly cable if necessary Each wire is labeled with the corresponding terminal numberSmooth the cut edges Then pull it out through the appropriate holePurging the indoor unit Cutting or extending the pipeUnscrew the caps at the end of each pipe Connect the pipesCorrect Inclined CrackedApplying the following torque Outer DiameterDrain hose installation Changing direction of the drain hosePurging the connected pipes Excessive torque can be cause of gas leakageAdding Refrigerant 1975 Covered by the Kyoto ProtocolPerforming the gas leak tests To check for gas leaks on the outdoor unitTo check for gas leaks on the indoor unit Leak test with nitrogen before opening valvesOutdoor unit installed on the wall by rack Fixing the outdoor unit in placePart without insulation on the end of the pipes Properly ModelPump down procedure when removing the product Press the Power button and check the followingPress the Mode button to select Cool or Heat mode Final Check and Trial OperationHow to connect your extended power cables Questions or COMMENTS?