Samsung ASV18PUQNXEA manual Cleaning the air conditioner, Slide it down, Close the front panel

Page 18

Cleaning the air conditioner

and slide it down.

Open the panel and put the A ter out.

 

Clean the A ter with a vacuum cleaner or soft brush.

 

 

If dust is too heavy, rinse it with running water.

 

 

 

 

 

 

Insert the A

ter back in its original position

 

Dry the Ai lter in a ventilated area.

and close the front panel.

 

 

 

 

 

 

 

 

 

 

• Clean the Air

every 2 weeks or when the

clean reminder lights up. Cleaning term may

depending

on the usage and environmental conditions. In dusty area, clean it once a week.

 

•When the ￿lter clean reminder is on, please press FILTER RESET button on remote controller.

•

•If the Air dries in a (or humid) area, odors may generate. If it occurs, re-clean and dry it in a well-ventilated area.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Air Conditioner Contents Follow directions Safety precautionsImportant safety symbols and precautions Wall socketFor Using For Cleaning Checking before use Operation rangesMain parts Power buttonChecking the name of the parts DisplayChecking the remote controller Remote controller buttonsStoring the remote controller Remote controller displayBattery changing time Inserting the batteriesBasic function Button to adjust the temperature PressCirculate the air Using the Turbo functionPress the Air swing button on the remote controller Position you preferMode Press the Set/Cancel button to active it on Press the button Press the button to set the timeTimer 5 hours Using the Smart Saver functionTimer 1 hour From the moment you have set the timerUsing the Quiet function Opening the panel Cleaning the indoor unitCleaning the outdoor unit heat exchanger Heat exchangerSlide it down Cleaning the air conditionerClean the Air Dry the Ai lter in a ventilated areaMaintaining the air conditioner Periodical checksTroubleshooting Outdoor unit Heat exchanger during Heat mode in winter If may not be aConnection General information Model Name Included Models RemarkPower supply line, fuse or circuit breaker Choosing the installation locationInstalling the unit Won’t be considered in-warranty and charged to end userOutdoor Unit ModelWhen installing more than 1 outdoor unit  When the air outlet is towards the wallTop view Side view Accessories Accessories in the indoor unit caseAccessories in the outdoor unit case Tools required for installation General Tools Fixing the installation plateOptional accessories Tools for test operationsConnecting the assembly cable Connecting the cableFix the indoor unit Extend the assembly cable if necessary Each wire is labeled with the corresponding terminal numberSmooth the cut edges Then pull it out through the appropriate holeUnscrew the caps at the end of each pipe Purging the indoor unitCutting or extending the pipe Connect the pipesApplying the following torque Correct InclinedCracked Outer DiameterDrain hose installation Changing direction of the drain hosePurging the connected pipes Excessive torque can be cause of gas leakageAdding Refrigerant 1975 Covered by the Kyoto ProtocolTo check for gas leaks on the indoor unit Performing the gas leak testsTo check for gas leaks on the outdoor unit Leak test with nitrogen before opening valvesPart without insulation on the end of the pipes Outdoor unit installed on the wall by rackFixing the outdoor unit in place Properly ModelPress the Mode button to select Cool or Heat mode Pump down procedure when removing the productPress the Power button and check the following Final Check and Trial OperationHow to connect your extended power cables Questions or COMMENTS?
Top Page Image Contents