Samsung ASV24PUQNXEA, ASV13PSPNXEA, ASV18PSPXXEA, ASV18PUQNXEA, ASV10PUQNXEA Outdoor Unit, Model

Page 24

Choosing the installation location

Outdoor Unit

Where it is not exposed to strong wind

Well ventilated and dustless places

Out of the direct sunlight and rain

Where neighbors are not annoyed by operation sound or hot air

Solid wall or support that prevents vibration and is strong enough to hold the product weight





3m or more away from the TV or radio (to prevent the screen from being distorted or noise from being generated)

Install the unit horizontally

Place where drained water does not become any problem.

Place with no plants (especially climbing plants) and where small animal can not access.

•Avoid the following places to prevent malfunction of the unit

- Where there is machine oil	- Salty environment such as seaside areas
	- Other special atmosphere areas

Observe the clearances and maximum lengths as seen in the picture below when installing the air conditioner.

If using a multi system, install the air conditioner as described in the installation manual supplied with the outdoor unit.

300mm or more

125mm or more

	Wrap the refrigerant pipes and the drain hose	You can select the direction of
	with the absorbent pad and vinyl tape. Refer to	You can select the direction of
	with the absorbent pad and vinyl tape. Refer to	draining
	page 38 for further details.	draining
	page 38 for further details.	(left or right).
		(left or right).
		'L' m as maximum pipe length
		and 3 m as minimum pipe length
		(It will reduce noise and vibration)
	600mm	' L ' meters maximum
	600mm	total pipe length
	minimum
	300mm
	minimum	300mm
		300mm
		minimum
	600mm
	minimum

125mm or more

'H ' meters maximum total pipe height

Model	L	H
10/13	15	7
18/24	30	15

Make at least one round: It will reduce noise and vibration



24

Image 24

Contents Air Conditioner Contents Safety precautions Important safety symbols and precautionsFollow directions Wall socketFor Using For Cleaning Checking before use Operation rangesPower button Checking the name of the partsMain parts DisplayChecking the remote controller Remote controller buttonsRemote controller display Battery changing timeStoring the remote controller Inserting the batteriesBasic function Button to adjust the temperature PressUsing the Turbo function Press the Air swing button on the remote controllerCirculate the air Position you preferMode Press the Set/Cancel button to active it on Press the button Press the button to set the timeUsing the Smart Saver function Timer 1 hourTimer 5 hours From the moment you have set the timerUsing the Quiet function Cleaning the indoor unit Cleaning the outdoor unit heat exchangerOpening the panel Heat exchangerCleaning the air conditioner Clean the AirSlide it down Dry the Ai lter in a ventilated areaMaintaining the air conditioner Periodical checksTroubleshooting Outdoor unit Heat exchanger during Heat mode in winter If may not be aConnection General information Model Name Included Models RemarkChoosing the installation location Installing the unitPower supply line, fuse or circuit breaker Won’t be considered in-warranty and charged to end userOutdoor Unit ModelWhen installing more than 1 outdoor unit  When the air outlet is towards the wallTop view Side view Accessories Accessories in the indoor unit caseAccessories in the outdoor unit case Fixing the installation plate Optional accessoriesTools required for installation General Tools Tools for test operationsConnecting the assembly cable Connecting the cableFix the indoor unit Extend the assembly cable if necessary Each wire is labeled with the corresponding terminal numberSmooth the cut edges Then pull it out through the appropriate holePurging the indoor unit Cutting or extending the pipeUnscrew the caps at the end of each pipe Connect the pipesCorrect Inclined CrackedApplying the following torque Outer DiameterDrain hose installation Changing direction of the drain hosePurging the connected pipes Excessive torque can be cause of gas leakageAdding Refrigerant 1975 Covered by the Kyoto ProtocolPerforming the gas leak tests To check for gas leaks on the outdoor unitTo check for gas leaks on the indoor unit Leak test with nitrogen before opening valvesOutdoor unit installed on the wall by rack Fixing the outdoor unit in placePart without insulation on the end of the pipes Properly ModelPump down procedure when removing the product Press the Power button and check the followingPress the Mode button to select Cool or Heat mode Final Check and Trial OperationHow to connect your extended power cables Questions or COMMENTS?