Samsung UE55ES8080UXZG manual IR Blaster, Initial Pairing, Installing batteries Battery size AA

IR Blaster

To control to external devices connected to your TV, setting up the Universal Remote.

If you control Smart Touch Control to adjust to the external device, the IR Blaster will send the IR signal to an external device.

Pairing Button

OPEN

PAIRING

1

Power Switch	OFF	1
	ON	2
		OPEN

Installing batteries (Battery size : AA)

1

1	OPEN
2	OPEN
1	OPEN
	OPEN

Device Indicator LED

IR Blaster shows the pairing state.

1.Hold the both sides of the battery holder and pull it out.

2.Install four batteries so that the polarity of the batteries (+/-) matches the illustration in the battery compartment.

3.Push it back.

Initial Pairing

When you connect an IR Blaster with your TV, you can control connected external devices with your TV using the Smart Touch Control.

IR receiver
	•	Smart Touch Control
30cm ~ 4m
	•	IR Blaster
<Connecting>	<Pairing complete>

Smart Touch Control

After you have run the Initial Setup on your TV, you should connect your Smart Touch Control to your TV.

1.Turn the TV on by pressing the Pbutton on.

2.The connection icons appear on the bottom left of the screen, and the TV connects to your Smart Touch Control automatically.

✎If you want to perform the pairing process again, press the reset button in the centre of the back cover using a pin or the tip of an unbent paper clip. The Smart Touch Control will be initialized.

• Smart Touch Control PAIRING Reset button

IR Blaster

1.Turn on the IR Blaster. When Indicator LED blinks, you should connect IR Blaster to TV.

2.Move the IR Blaster to the direction of your TV's IR receiver, and then press the PAIRING button once

OPEN	shortly on the bottom of the IR Blaster.
PAIRING	3. The connection icons appear on the bottom left of the screen, and the TV connects to IR Blaster
ON	automatically.
OFF
PENO	✎ If the connection process failed, please turn off and on the IR Blaster, try again from step2.

English - 7