Remington QFP40 manual Installation, Minimum Framing Dimensions

INSTALLATION

REMINGTON QFP40 Direct Vent FIREPLACE

MINIMUM FRAMING DIMENSIONS

❖The 1/2" stand-offs on the back and sides and 4" stand-offs on the top of the fireplace separate the fireplace from the framing members (see page 12, Installation Terminology). These stand-offs may contact the framing mem- bers but no material may be placed between the stand-offs and the framing.

❖Installation requires a level surface capable of supporting the weight of the fireplace (240 lbs.) and vent.

❖Fireplace must be placed directly on wood or non-combustible surface (not on linoleum or carpet).

❖HOT WHILE IN OPERATION! Installation location must be out of traffic and away from furniture and draperies.

NOTE: Framing dimensions shown below reflect an 1/4" overage on top and 1/8" overage to each side.

56 1/2"

45 1/2"
19 5/8"	Route electrical
	line to the right
	rear of fireplace.

43"

Route Gas Line 6 7/16" behind the framing opening (on either side of can). For hardpipe connection, allow 1 1/4" above the base of fireplace.

Page 16 250-4721 JUNE 2001