REMINGTON QFP40 Direct Vent FIREPLACE
MAINTENANCE
GENERAL
Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, et cetera. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean.
GLASS CLEANING
WARNING! DO NOT CLEAN GLASS WHEN HOT! TURN UNIT OFF AND ALLOW TO COOL. DO NOT USE ABRASIVE CLEANERS ON GLASS SURFACE!
✔Turn off pilot light.
✔Remove fascia.
✔Open door by releasing four spring latches, two on top and two on bottom of glass. ✔Using glass cleaner, wipe with soft cloth or clean paper towel until surface is dry. ✔Relight pilot.
✔Close door.
✔Replace Fascia.
✔Check main burner’s operation.
NOTE: If you observe a white film on the door glass, use a hard water deposit glass cleaner or contact your dealer. The use of a glass cleaner will reduce the mineral deposits.
NOTE: Do not use abrasive materials or chemical cleaners.
Refer to page 61 for Glass Replacement instructions.
GOLD OR NICKEL FASCIA - CARE AND TREATMENT
WARNING! You must clean all the fingerprints and oils from gold or nickel surface prior to firing the fireplace for the first time.
Use a glass cleaner or vinegar and a very soft towel to remove the oils. If gold or nickel fascia is not cleaned properly prior to lighting the first fire, the oils remaining from fingerprints can cause permanent markings on the gold plating. After the plating is cured, the oils will not affect the finish and regular maintenance can be provided using glass cleaner and a very soft cloth as needed.
MAINTENANCE
Page 59