Remington QFP40 manual Operation, Control Panel

OPERATION

REMINGTON QFP40 Direct Vent FIREPLACE

OPERATION

Read this entire manual prior to using the fireplace. Pay particular attention to the “Safety Precautions” section on pages 6-9. Failure to follow the instructions may result in prop- erty damage, bodily injury, or even death.

CONTROL PANEL

Main Burner	Fan Speed
Comfort Control

Thermostat	Valve Control
Connection		Ignitor

FAN SPEED This knob controls the speed of the internal convection blower that pushes the heated air into the room.

MAIN BURNER	This control is used to turn the fireplace on and
	off.
PILOT IGNITOR	The pilot ignitor is used only to start the pilot.
	When pressed, it sends an electrical charge to
	the pilot assembly. This creates a blue spark
	directly next to the pilot, igniting the pilot flame.
VALVE CONTROL	This knob is used to control gas to the fireplace
	and for starting the pilot. There are three posi-
	tions, ON, OFF, & PILOT. The pointer on the
	panel indicates the position of the knob.
COMFORT CONTROL	This knob controls the flame height from low
	(“LO”) to high (“HI”).

•If using a remote control or thermostat, the On/Off Switch must be left “OFF”. Turning the On/Off Switch “ON” will keep the fireplace on continually.

Page 58 250-4721 JUNE 2001