Quadra-Fire CASTILEI-MBK owner manual Getting Started, Appliance Location

Page 5

 

R

 

Castile Pellet Insert

 

 

2

Getting Started

A. Design, Installation & Location Considerations

1.Appliance Location

NOTICE: Check building codes prior to installation.

•Installation MUST comply with local, regional, state and national codes and regulations.

•Consult insurance carrier, local building inspector, fire officials or authorities having jurisdiction over restrictions, installation inspection and permits.

It is a good idea to plan your installation on paper, using exact measurements for clearances and floor protection, before actually beginning the installation

Consideration must be given to:

•Safety, convenience, traffic flow

•Placement of the chimney and chimney connector.

•If you are not using an existing chimney, place the appli- ance where there will be a clear passage for a factory- built listed chimney through the ceiling and roof.

•Installing an optional outside air kit would affect the loca- tion of the vent termination.

Since pellet exhaust can contain ash, soot or sparks, you must consider the location of:

•Windows

•Air Intakes

•Air Conditioner

•Overhang, soffi ts, porch roofs, adjacent walls

•Landscaping, vegetation

When locating vent and venting termination, vent above roof line when possible.

Warning! Risk of Fire Damaged parts could impair safe operation. Do NOT install damaged, incomplete or substitute components.

CAUTION! If burning shelled field corn, you must use ap- proved venting specifically designed for corn to prevent corro- sion or degradation. Follow the instructions from the venting manufacturer.

NOTICE: Locating the appliance in a location of considerable air movement can cause intermittent smoke spillage from appliance. Do not locate appliance near:

•Frequently open doors

•Central heat outlets or returns

 

Recommended Location:

Recommended Location:

•

Above peak

• Above peak

•

Inside heated space

Location NOT recommended:

•Not the highest point of the roof

•Wind loading possible

Windward

Marginal Location:

• Below peak

Recommended:

•Insulated exterior chase in cooler climates

Marginal Location:

• Wind loading possible

Location NOT recommended:

• Too close to tree

• Below adjacent structure

• Lower roof line

• Avoid outside wall

Leeward

Recommended: Outside Air Intake on windward side

Multi-level Roofs

NOT recommended: Outside Air Intake on leeward side

Figure 5.1

January 19, 2011

7022-122

Page 5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Hot glass will cause burns Castile Pellet InsertWelcome to the Quadra-Fire Family Castile Pellet InsertTable of Contents Appliance Certification BTU & Efficiency Specifications Listing and Code ApprovalsMobile Home Approved Glass SpecificationsAppliance Location Getting StartedDraft Castile Pellet Insert Locating Your Appliance & ChimneyNegative Pressure Minimum Vacuum Requirements 095Castile Pellet Insert Avoiding Smoke and Odors Negative Pressure, Shut-Down and Electrical Power FailureVent Configurations Outside AirInspect Appliance & Components Castile Pellet Insert Fire SafetyTools And Supplies Needed Pre-Burn Check ListAppliance Dimensions 3Dimensions and ClearancesShown with Rear Vent and Outside Air Must be installed in a non-tapered enclosureCastile Pellet Insert Clearance To Combustibles, UL and ULC Minimum Opening for Masonry and Factory-Built Fireplaces Masonry and Factory-Built FireplacesCastile Pellet Insert Floor Protection Prefabricated Metal ChimneyAltering the Factory-Built Fireplace Using a saws-all, cut out the floorVenting Termination Requirements Vent InformationChimney and Exhaust Connection Minimum Vent for One Elbow Castile Pellet Insert Pellet Venting ChartsHorizontalHori tal Run,RunftFT MinimumVertical Vent for Three ElbowsFull Reline With Horizontal Outside Air 5Venting SystemsCastile Pellet Insert Full Reline With Vertical Outside Air 6Mobile Home Mobile Home InstallationOutside Air Kit Instructions 7Appliance Set-UpLeveling System Ance. Shown in Figures 18.1Door Removal Adjustable Hearth SupportCastile Pellet Insert Door Handle Removal 20.7 Ex the sides into a bowed position before installing21.4 Surround & Trim Set, EconoSurround and Cast Trim Set Castile Pellet Insert Surround & Trim Set, Econo Cont’dPiece. Figure Shown in Figure .2 onTwo Piece Log Set Installation Castile Pellet Insert Thermostat Installation Fuel Material and Fuel Storage Operating InstructionsCombustible/Non-Combustible Materials Before Your First Fire Castile Pellet Insert General Operating InformationClear Space Thermostat Calls For HeatCastile Pellet Insert Starting Your First Fire Fire CharacteristicsFeed Rate Adjustment Instructions Castile Pellet Insert Ignition Cycles Frequently Asked QuestionsTurn down thermostat and let the appliance completely cool Page Symptom Possible Cause Corrective Action Maintaining & Servicing Your Appliance Quick Reference Maintenance ChartTypes of Fuel FrequencyCleaning Ash Drawer Cleaning Firepot with Cleaning Rod & Firepot Clean-Out ToolSee .1 on Ash Removal from Firebox Disposal of Ashes Frequency As neededCleaning Beneath Heat Exchanger Cleaning Heat Exchanger TubesCleaning the Glass Door Latch InspectionCleaning Exhaust Blower Requires No Lubrication Cleaning the HopperCleaning Convection Blower Requires No Lubrication Preparing Firebox for Non-Burn SeasonImmediate Attention and Cleaning is Required Castile Pellet Insert High Ash Fuel MaintenanceConvection Blower Replacement Castile Pellet Insert Combustion Blower ReplacementGlass Replacement Castile Pellet Insert Igniter ReplacementCastile Pellet Insert Baffle & Brick Set Removal Re-installing Baffle & Brick SetCastile Pellet Insert Re-installing Baffle & Brick Set Cont’d Component Function Reference MaterialsWiring Schematic See .1 below Vacuum SwitchThermostat Snap Disc #1 Convection Blower 110FCastile Pellet Insert Component Locations Cleaning Rods & Heat Exchanger TubesCastile Pellet Insert Service PartsPart number list on following pages Stocked At DepotStocked at Depot #23 Door Assembly#28 Feed Assembly #38 Firepot and Associted Parts StockedOptional Accessories SP-CSTLI5134 Description Comments Part Number Fasteners Service And Maintenance Log Service And Maintenance Log Cont’d Homeowner’s Notes Limited Lifetime Warranty Warranty Conditions Contact Information
Top Page Image Contents