![](/images/new-backgrounds/1051711/5171143x1.webp)
R
5100-I ACT WOOD INSERT
2.Assembling Trim
a.Place protective covering on surface to be used to assemble the trim pieces. Lay the trim face down.
b.Attach the 2 side trim pieces to the top trim at each corner using the “L” bracket included in fasteners package. Slide assembled trim over panel set.
Figure 22.1.
NOTE: If you have a mantel, you may need to install the trim on your panels before you push the insert into the fireplace opening. If not, you can slide the trim over the panel set after the insert is in its final position.
D. Securing Liner to Flue Collar
There are two options to secure the liner to the flue collar:
Option One: If there is enough room on the top of the insert to work, hand bend the 2 tabs upward 90°. Secure the liner with the supplied hex head bolts
Option Two: Remove the manifold tubes, fiberboard baffle and ceramic blanket. From inside the firebox, pull liner down through the chimney ring below the outer skin. There are 2
View of “L” bracket installed
2
Figure 22.1
Attach liner with 2 tabs
Figure 22.2
NOTE: Tabs are shipped from factory in a flat position. Bend upwards 90 degrees as show in Figure 22.2
Page 22 | April 21, 2010 |