![](/images/new-backgrounds/1051711/5171167x1.webp)
R
5100-I ACT WOOD INSERT
E.Door Handle Assembly Replacement
•Frequency: As needed
•By: Homeowner / Qualified service technician
•Task: See the following instructions.
1.Install washer on door handle shaft.
2.Slide door handle through door.
3.Install second washer(s) as shown.
4.Install key in groove.
5.Align groove in latch cam with key; slide latch cam over shaft
6.Install locknut.
7.Install spring handle turning in a
F. Blower Replacement
•Frequency: As needed
•By: Homeowner / Qualified service technician
•Task: See the following instructions.
1.Remove the panel and trim set. See pages
2.Remove 2 screws on blower housing.
3.Unhook the wires from the blower.
4.Slide blower housing out.
5.Remove 2 screws from blower and remove from housing.
6.Attach new blower to housing.
7.
Latch Cam | Door Cross | |
Section | ||
|
Locknut
Spring Handle
Door Handle
Spacing Washers
Square Key
Figure 34.1
CAUTION
•Do NOT overtighten lock nut.
•Door handle needs to move smoothly.
Remove
2 Screws
Figure 34.2
Figure 34.3
Page 34 | April 21, 2010 |