
|
|
|
|
| R | |||
|
|
|
|
|
| |||
|
|
| Appliance |
|
|
|
| |
|
|
|
|
|
| |||
|
|
|
|
|
| |||
|
| Installation Outline |
| C. Panel & Trim Set Installation | ||||
|
|
| Standard Size: | |||||
A.7 |
|
| ||||||
1. | Record serial number on back cover of manual. | Large Size: | ||||||
2. | Remove the leveling bolts from the component pack and | |||||||
Kit Includes: | Tools Needed: | |||||||
|
| start the bolts in the weld nuts. Figure 21.1. | ||||||
3. | Position insert on hearth with rear of insert extending into | (2) Side panels, left & right | Screwdrivers: | |||||
(1) Panel top & fastener package | Powered Phillips head | |||||||
|
| fireplace opening. Slide insert on its base into the open- | (2) Side trim, left & right | |||||
|
| ing leaving approximately 4 inches (102mm) protruding | (1) Trim top & fastener package. |
|
|
out the front.
4.Assemble the panels and temporarily attach to insert.
Push insert into opening leaving 1 inch (25mm) protrud- ing out the front. Confirm the panel size is correct for the opening and that the face can be sealed off from room air when installation is complete. Figures 21.2 & 21.3.
5.Remove the panels and secure liner to the chimney ring.
6.Level the insert in its final position in the fireplace. If an offset adapter is required for installation, install it first and then secure liner to offset adapter.
7.Install the Panel & Trim set and (if applicable) the Zero Clearance Trim Support.
1.Attaching Panels to the Insert
a.Loosely install the 2 side panels, do not tighten, using the cage nuts already attached to the appliance.
(Note: The sides are not interchangeable). Figure 21.3.
b.Put top panel in place pushing straight back and then to the right to lock onto top of side panels. Attach the top panel to the sides using the panel brackets included in the fasteners package. Figure 21.2.
c.Tighten side panels to the appliance using a long- handle screw driver.
B. Leveling Bolts
Two leveling bolts, 3/8” x 4” are shipped inside the com- ponent pack found inside the firebox.
NOTE: Not all installations will require the use of the level- ing bolts.
1.Remove the bolts from the component pack and insert into weld nuts welded to each side of the insert bottom
Figure 21.1.
2.After securing the liner to the flue collar (or offset adapter) and the insert is in its final position, extend bolts down- ward to level insert.
,EVELINGI"OLT
Figure 21.1
Panel brackets
Do not tighten sides until top is locked into place
Figure 21.2
Back view of top and side panel assembled
Cage nut
Panel bracket
Figure 21.3
April 21, 2010 | Page 21 |