Quadra-Fire 5100I-NL-B Listing and Code Approvals, Mobile Home Approved, Glass Specifications

		R	5100-I ACT WOOD INSERT
A.	1	Listing and Code Approvals
	Appliance Certification		D. BTU & Efficiency Specifications

MODEL:	5100-I ACT Wood Insert
LABORATORY:	OMNI Test Laboratories, Inc.
REPORT NO.	061-S-59-2
TYPE:	Solid Fuel Type, Wood Stove Insert
STANDARD:	UL1482 and ULC S628 and (UM)
	84-HUD, Mobile Home Approved.

The Quadra-Fire 5100-I ACT Wood Inserts meets the U.S. Environmental Protection Agency’s 1990 particulate emis- sion standards.

B. Mobile Home Approved

This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided. The structural integrity of the mobile home floor, ceiling, and walls must be maintained.

The appliance must be properly grounded to the frame of the mobile home and use only listed double-wall connector pipe. An Outside Air Kit comes standard on the appliance and must be installed in a mobile home installation.

C. Glass Specifications

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the UL1482, (UM) 84-HUD and NFPA211 in the U.S.A. and the ULC S628-93 and CAN/CSA-B365 Installation Codes in Canada.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

EPA Certified:	1.9 grams/hour
Efficiency:	up to 84.4%
BTU Output:	11,600 to 48,200
Heating Capacity:	2,250 to 3,175 sq ft depending on
	climate zone
Maximum Log Length:	12 inches
Firebox Capacity:	3.0 cubic feet
Weight:	520 lbs

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire - If appliance or chimney connector glows, you are overfiring.

Any such action that may cause a fire hazard.

NOTE: Hearth & Home Technologies grants no war- ranty, implied or stated, for the installation or mainte- nance of this unit and assumes no responsibility for any consequential damage(s).

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

Page  438-0380E April 21, 2010