Designer Series Gas Fireplaces | INSTALLATION INFORMATION |
INSTALLATION AND OPERATING INSTRUCTIONS
This gas fireplace should be installed by a qualified installer in accordance with local building codes and with current
FOR U.S.A. Installations follow local codes and/or the current National Fuel Gas Code. ANSI Z223.1.
fireplace location
For Safe Installation and Operation Please Note The Following:
1.This fireplace gives off high temperatures and should be located out of high traffic areas and away from furniture and draperies.
2.Children and adults should be alerted to the hazards of the high surface temperatures of this fireplace and should stay away to avoid burns or ignition of cloth- ing.
3.Caution, due to high glass surface temperature children should be carefully supervised when they are in the same room as the fireplace.
4.Under no circumstances should this fireplace be modi- fied. Parts removed for servicing should be replaced prior to operating the fireplace again.
5.Installation and any repairs to this fireplace should be carried out by a qualified service person. A profes- sional service person should be contacted to inspect this fireplace annually. Make it a practice to have all of your gas fireplaces checked annually. More frequent cleaning may be required due to excess lint and dust from carpeting, bedding material, etc.
6.Control compartments, burners and air passages in this fireplace should be kept clean and free of dust and lint. Make sure that the gas valve and pilot light are turned off before you attempt to clean this fireplace.
7.The venting system (chimney) of this fireplace should be checked at least once a year and if needed your venting system should be cleaned.
8.Keep the area around your fireplace clear of combus- tible materials, gasoline and other flammable vapor and liquids. This fireplace should not be used as a drying rack for clothing, nor should Christmas stockings or decorations be hung on or around the fireplace.
9.Under no circumstances should any solid fuels (wood, coal, paper or cardboard etc.) be used in this fire- place.
10.The flow of combustion and ventilation air must not be obstructed in any way.
11.When the fireplace is installed directly on carpeting, vinyl tile or any combustible material other than wood, the fireplace must be installed on a metal or wood panel extending the full width and depth of the fireplace.
12.This fireplace requires adequate ventilation and com- bustion air to operate properly.
13.This fireplace must not be connected to a chimney flue serving a separate solid fuel burning fireplace.
14.When the fireplace is not in use it is recommended that the gas control valve be left in the “OFF” position.
This appliance has been approved for
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
Remove any plastic from trim parts before turning the fireplace ON.
It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
It is not unusual for your Monessen gas fireplace to give off some odor the first time it is burned. This is due to the curing of the paint and any undetected oil from the manu- facturing process.
Please ensure that your room is well ventilated — open all windows.
It is recommended that you burn your Monessen fireplace for a least ten (10) hours the first time you use it. If the optional fan kit has been installed, place the fan switch in the “OFF” position during this time.
10 | 42D0200 |