Monessen Hearth CR, PF, CL)NVC/PVC, 624DV(ST manual Product features, High Elevations

Page 5

product features

Designer Series Gas Fireplaces

product SPECIFICATIONS

This appliance has been certified for use with either natural or propane gas. See appropriate data plates.

This appliance is not for use with solid fuels.

The appliance is approved for bedroom or bedsit- ting room installations.

The appliance must be installed in accordance with local codes if any. If none exist use the cur- rent installation code. ANSI Z223.1/NFPA 54 in the USA, CSA B149 in Canada.

This appliance is mobile home approved.

This appliance is approved for bathroom instal- lation.

The appliance must be properly connected to a venting system.

The appliance is not approved for closet or recessed installations.

The efficiency rating of this appliance is a product thermal efficiency rating determined under con- tinuous operating conditions and was determined independently of any installed system.

HIGH ELEVATIONS

Input ratings are shown in BTU per hour and are certi- fied without deration for elevations up to 4,500 feet (1,370 m) above sea level.

For elevations above 4,500 feet (1,370 m) in USA, installation must be in accordance with the current ANSI Z223.1/NFPA 54 and/or local codes having jurisdiction.

In Canada, please consult provincial and/or local authorities having jurisdiction for installation at eleva- tions above 4,500 feet (1,370 m).

GAS pressures

 

Natural

Propane (LP)

Inlet Minimum

4.5” w.c.

11.0” w.c.

Inlet Maximum

10.5” w.c.

13.0” w.c.

Manifold Pressure

3.5” w.c.

10.0” w.c.

 

 

 

Optional

 

Remote

 

Receiver

 

Hi/Lo Knob

FP2276

 

Off/Pilot/On

 

Knob

 

Control Panel

Blower Control

Figure 1 -

Designer Series Fireplace Controls

Before You START

Read this homeowner manual thoroughly and follow all instructions carefully. Inspect all contents for shipping damage and immediately inform your dealer if any damage is found. Do not install any unit with damaged, incomplete, or substitute parts. Check your packing list to verify that all listed parts have been received. You should have the following:

Fireplace (Firebox and Burner System)

Log Set

Lava Rock

Rock Wool

Deflector Shield (to be used with Simpson DuraVent Horizontal Termination – P/N 985)

Items Required For Installation

Phillips Screwdriver

Framing Materials

Hammer

Wall Finishing Materials

Saw and/or saber saw

Level

Measuring Tape

Electric Drill and Bits

Tee Joint

Pliers

Square

Pipe Wrench

Caulking Material (Noncombustible)

Fireplace Surround Material (Noncombustible)

Piping Complying with Local Codes

Pipe Sealant Approved for use with Propane/LPG (Resistant to Sulfur Compounds)

Gas Specifications & ORIFICE SIZE

 

 

Max.

Min.

 

 

 

Input

Input

Orifice

Model

Fuel

Btu/h

Btu/h

Size

624DVNVC

Nat.

36,000

25,000

#44

624DVPVC

LP

36,000

26,000

#54

624DVNEC

Nat.

36,000

25,000

#44

624DVPEC

LP

36,000

26,000

#54

42D0200

Image 5
Contents Designer Series Direct Vent Gas Fireplace Designer Series Gas Fireplaces Owner InstallerCode Approval Important Safety Information and code approvalPlease Read the Following Carefully Never connect unit to private nonHigh Elevations Product featuresFireplace Dimensions Peninsula Framing Peninsula & Corner Framing SpecificationsFireplace Framing Framing Fireplace See-through Framing SpecificationsClearances to combustibles ClearancesMantel clearances Finishing MaterialFireplace location Installation and Operating InstructionsSecurE fireplace to floor InstallationOptional top vent application Optional TOP Vent installationVenting Clearances VentING installationInstallation precautions 42D0200 General Venting Information Termination Location VentING installationCanadian Installations1 US Installations2 Feet How To Use The Vent GraphDimensions Top View Flat Installation Rear Wall Vent installationInstalling Horizontal Vent Cap Adhered to Horizontal termination configurationsExample Horizontal termination configurationBelow Grade Installations Vertical through-the-roof applications Flat ceiling installation Installation for vertical terminationConnect a section of pipe and extend up through the hole Installing gas piping to fireplace / burner system location Fireplace installationInstallation items needed Check gas typePropane/LP Natural GasServicing controls. Wiring errors can cause Electrical WiringLabel all wires before disconnecting when Do not connect wall switch to 110 V circuit Electrical installationRemote Wall mounted Switch Optional DC Remote Systems Electronic Pilot Ignition WiringRemote Wall Switch Glass Frame Removal Glass removalInstall logs and rock wool ember material in firebox LOG PlacementLog placement Install Top Log #6 Log placementVenting Height feet Grille Opening AIR Restrictor AdjustmentNever use an open flame to check for gas leak What to do if YOU Smell GASInitial lighting Flame Approved leak testing methodNever check for gas leak with open Pilot position Main burner switchLighting the burner Cleaning glass Cleaning and maintenanceFirebox cleaning Venting systemStanding Pilot Ignition TroubleshootingYES TroubleshootingElectronic Ignition Optional Blower accessory Blot General troubleshootingGlass replacement and blower Description Qty Natural Propane Replacement partsLogs Replacement Parts are Available Through Your Retailer LP to Natural Gas Standing Pilot Millivolt ControlFuel Conversion Kits Millivolt Natural Gas to LP Electronic Ignition Replacement PartsVent Components Replacement PartsDesigner Series Gas Fireplaces Designer Series Gas Fireplaces Designer Series Gas Fireplaces Carbon Monoxide Detector Requirements Five Year Warranty Lifetime WarrantyBasic Warranty If Warranty Service is NeededModel EnerGuide Ratings Fireplace Efficiency % Mhsc