Monessen Hearth KHLDV400, KHLDV500 operating instructions Timer Mode, Thermostat Mode

Page 41
Figure 55
Figure 54

TOUCH SCREEN REMOTE CONTROL OPERATION

KHLDV Series Gas Fireplace

1.Press the ON/up button to turn on the fireplace. The flame icon on the LCD displays

High.

2.Press the OFF/down button to decrease the flame height and turn off the fireplace. When the OFF/down button is pressed for three times, the flame icon changes form High to Medium, to Low, then to Off.

3.If the OFF button is held for more than 3 seconds at any flame height, the fireplace will be turned off and the flame icon disappears.

4. Sliding up and down on the ar-

row buttons can also turn on or turn off the fireplace.

5.If the fireplace is shut off using the above methods in 3 and 4, all the settings will be remembered and will be resumed next time the fireplace is turned on (Memory Off).

Timer Mode

Figure 55

Press the TIMER button to enter timer mode. The fireplace will stay on for a period of time as specified by the timer and then be shut off by the transmitter when the timer counts down to zero.

1.When the TIMER button is pressed, the Set Time appears in the frame of the button and flashes.

2.Use ON/up and OFF/down to

increase or decrease the Set

Time in 15 min. increments, between 0:00 to 6:00. Sliding up and down on the arrow buttons will increase

c. Slide down on the arrow buttons to exit TIMER mode and shut off the fireplace.

Thermostat Mode

Figure 56

Press the THERMO button to set the transmitter in thermostat mode. The transmitter will au- tomatically turn on the fireplace when the room temperature is below the set temperature and turn off the appliance when the room temperature is above the set temperature within one de- gree.

1. When the THERMO button is

pressed, the Set temperature

Figure 56

appears in the frame of the

 

button and flashes.

 

2.Use ON/up and OFF/down to increase or decrease the Set temperature in 1 degree increments, between 45 degrees and 90 degrees. Slide up and down on the arrow buttons will increase or decrease the Set Tem- perature in 10 degrees increments.

3.Press the THERMO button again to confirm the Set Temperature. The transmitter will send out an On signal or an Off signal depending on the relationship between the Set temperature and the Room tempera- ture.

4.The flashing stops and the ON/up and OFF/down but- tons become flame height controller again. The flame height will then stay as set up by the ON/up and OFF/ down buttons.

5.To exit Thermostat Mode:

a.push and hold the THERMO buttons for 3 sec- onds or

b.slide down on the arrow buttons to exit Thermo- stat mode and shut off the fireplace.

or decrease the Set Time in 1 hour increments.

3.Push the TIMER button again to confirm the Set Time, the transmitter sends an ON signal to turn on the fire- place.

4.The flashing stops and the ON/up and OFF/down but- tons become flame height controller again. The flame height will then stay as set up by the ON/up and OFF/ down buttons.

5.The TIMER button can be used when the transmit- ter is in Manual Mode or in Thermostat Mode. In both modes, the fireplace will be shut down completely when the timer counts down to zero.

6.To exit Timer Mode,

a.Push and hold the TIMER button for 3 seconds Or

b.Use the OFF/down buttons to decrease the Set Time to zero Or

Smart Mode Option for Thermostat Mode Figure 57

Press and hold the THER- MO button and the ON/UP button at the same time for 3 seconds to toggle be- tween Smart Mode and the regular Thermostat Mode. The icon “Smart Mode” will appear under the Set Tem- perature. The transmitter will automatically adjust the flame height according to the difference between the Set temperature and the Room temperature. There

Smart

Mode

Icon

Figure 57

73D0024

41

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Khldv Series Direct Vent Gas Fireplace Signature Command System Operation Instructions Operating Instructions Signature CommandOwner InstallerCode Approval Important Safety Information and Code ApprovalNever connect unit to private non Utility gas wells. This gas is commonlyGas Specifications & Orifice Size Product featuresHigh Elevations GAS pressuresKHLDV400 KHLDV500 Fireplace and Framing DimensionsBefore You Start PRE-INSTALLATION InformationFirebox framing Cold Climate InsulationFireplace Location PRE-INSTALLATION InformationClearances to combustibles ClearancesMantel clearances Side ViewSECURe Fireplace to floor or framing Never install combustible materialsFinishing Material Over front face of fireplaceInstallation precautions Venting InstallationFailure to follow these instructions will void Warranty LifeInstalling a vent system in an outside chase Installation planningFor horizontal termination For vertical terminationGeneral Venting Information Termination Location Canadian Installations1 US Installations2Outside Corner How To Use The Vent GraphStep Vertical Sidewall InstallationAlways install horizontal venting on a level plane 610 mm Mm Max VERTICAL/Horizontal termination configurationsTo be installed around the termination area VentING installationBelow Grade Installations Vertical through-the-roof applica- tions VentNG installationExample Installation for vertical termina- tionFlat ceiling installation Termination Heights for Vents Above Flat or Sloped Roofs Check gas type Fireplace installationInstalling gas piping to fireplace / burner system location Propane/LP Natural GasMillivolt Checking GAS Pressure and Electrical installation Remote Wall mounted Switch Millivolt Remote Wall Switch InstallationDo not connect wall switch to a 110V circuit Optional Fan/Blower System BlotkhlWA RNI GN Millivolt Optional FAN/BLOWER SystemBlower Access Covers What to do if YOU Smell GAS Millivolt Operating InstructionsInitial lighting Never use an open flame to check for gas leakNever check for gas leak with open flame Approved leak testing methodPilot position Main burner switchLighting the burner Electrician. Main power must be off when Optional Accessory RequirementsConnecting to main electrical power supply Or performing service. All wiring shall beCommand Center Wall Installation Junction BOX WiringWall Switch Installation Do not connect wall switch to 110Electrical Installation Blotkhlsc Signature Command Blower Signature command Optional fan blower systemSignature command Operating Instructions OPERATing Instructions Command CenterCommand Center FeaturesBattery Installation Function Operation Default Setting System CONFIGURATION/SETUPKey Combinations for System Settings Function Operation Command Center OperationsSelf Diagnostics Chart Perature before accurate room temperatures Due to the sensitive temperature monitoringFor accurate temperature readings to appear on Turn appliance OFF at the Master Switch ifDo not use two 2 or more remote control sys Setting Privacy Code on TransmitterCode setting, as they will communicate with Resetting the transmitterSmart Mode Option for Thermostat Mode Figure Timer ModeThermostat Mode Light Brightness Control Blower On Delay Time and Off Delay Time Setup FigureBlower Speed Control AUX Control Rear Burner On/Off Control Safety FeaturesSetting up Blank Screen or Constant Display in Idle Symptom Causes Action Using the Mounting BaseGlass Frame Removal Glass removalRock wool placement Final installationBRICK, light bulb, and lens placement LOG placement Log placementPlace the upper right rear log over the rear log Burner, Pilot and Control Compart- ment Cleaning and maintenanceVent SysteM Cleaning and maintenanceGlass Door LogsPoSSIBLE Cause TroubleshootingStanding Pilot Ignition Troubleshooting Troubleshooting Signature Command SystemFirebox components and accessories Replacement PartsAccessories / Field Installed Options Description QtyStanding Pilot Millivolt control Replacement PartsLP to Natural Gas AccessoriesFuel Conversion Kits Millivolt Control Natural Gas to LP Signature Command System KHLDV400 KHLDV500 Logs VENTing components Or Mhsc Selkirk Box Description Venting Components for 5xCurrent Old Simpson Duravent Manufacturer Requirements Requirements for the Commonwealth of MassachusettsBasic Warranty Lifetime WarrantyFive Year Warranty Model EnerGuide Ratings Mhsc
Related manuals
Manual 1 pages 58.97 Kb Manual 1 pages 53.14 Kb

KHLDV500, KHLDV400 specifications

The Monessen Hearth KHLDV400 is a high-performance gas fireplace designed to provide both warmth and aesthetic appeal to any living space. This unit is engineered with modern technology, making it an excellent choice for homeowners looking to enhance their home’s atmosphere while enjoying the benefits of efficient heating.

One of the standout features of the KHLDV400 is its impressive heating capability. With an input of 40,000 BTUs, this gas fireplace is capable of heating spaces effectively, making it perfect for medium to large rooms. This fireplace utilizes a direct vent system, ensuring that combustion gases are efficiently expelled outside, while fresh air is drawn from the exterior to support the flame. This makes for a safe and environmentally friendly operation, as it minimizes indoor air pollution.

The KHLDV400 also boasts an innovative burner design that creates realistic flames, mimicking the look of traditional wood-burning fires. The fireplace comes with a choice of decorative media options, including glowing embers and fire glass, allowing homeowners to customize the look of their fireplace to match their personal style.

Another notable characteristic of the KHLDV400 is its intuitive control system. It can be operated via a handheld remote or wall switch, providing convenience and ease of use. Homeowners can adjust the flame height and heat output with simple controls, ensuring comfort at all times. Additionally, it features a standing pilot option that enhances its reliability and safety during operation.

Durability and quality craftsmanship are hallmarks of the Monessen brand, and the KHLDV400 is no exception. The fireplace is built with high-quality materials designed to withstand the test of time. Its sleek, contemporary design features a clean-face appearance that enhances any decor, while the glass front allows for an unobstructed view of the beautiful flame display.

With its combination of style, advanced technology, and efficient heating capabilities, the Monessen Hearth KHLDV400 is an exceptional choice for those looking to invest in a gas fireplace that delivers both performance and elegance to their home.
Top Page Image Contents