Monessen Hearth KHLDV500 Millivolt Remote Wall Switch Installation, Remote Wall mounted Switch

KHLDV Series Gas Fireplace Millivolt - REMOTE WALL SWITCH INSTALLATION

Remote Wall mounted Switch

A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. Attach the wall switch in a junction box at the desired location on the wall. Figure 31. Do not extend beyond the wall switch wire length provided.

NOTE: Extended lengths of wire may cause the fireplace not to function properly. Longer length of wire is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local code.

OFF

PILOT		HI
	ON	TH
		TP

TH/TP

			OPTIONAL REMOTE
			WALL SWITCH
			ON
ON	OFF	RS	OFF

WARNING

Do not connect wall switch to a 110V circuit.

Figure 31 -

Wiring Diagram for Wall Switch

CAUTION	Electrical connections should only be performed
	service.
	by a qualified, licensed electrician. Main power
	supply must be turned off before connecting fans
	to the main electrical power supply or performing

Optional Fan/Blower System (BLOTKHL)

important: Always check local building codes. This installation must comply with local regulations as well as the National Electric Code.

WIRING

1.Before installing the blower, wire the receptacle into an electrical circuit. This should be done before framing the fireplace. Wire with minimum 60°C wire in accordance with prevailing codes.

2.Remove the external junction box cover by removing the screw from the right side of the outside firebox wall. Junction box was installed at the factory.

3.The junction box cover has a factory installed “romex” style strain relief connector. After connect- ing the wires, route the wire leads through this connector. Refer to the wiring diagram in Figure 33.

BEFORE INSTALLING BLOWER

1.Always turn off the gas supply and allow the unit to cool before proceeding.

2.Clean the inside of the firebox (wall and floor), where the blower and wires will be installed. Make sure the firebox wall and floor are clean and dry before mounting the blower.

WARNING

Before installing the blower, turn off the fireplace and allow to cool. Only a qualified service person should service and repair the fireplace. A qualified service person should connect and disconnect the fireplace to gas supply. Follow all local codes.

NOTE: It is very important to arrange the blower wires and wire assembly so that wires do not come in contact with blower blades or firebox.

INSTALLING BLOWERS

1.Remove screen rod assemblies by lifting rod and pushing back and down to release rod from the three hooks located behind the face of the fireplace on the right, left, and middle.

2.Remove the plate located in front of the glass at the bottom.

3.Rotate the access doors on the right and left side of the glass toward the glass.

4.Remove glass frame by releasing the three latches located at the top of the firebox. Tilt glass away from the unit, lift glass frame up and away from the unit. Page 45

5.Remove logs.

6.Remove hearth brick, wall brick and rear brick. NOTE: Remove brackets that secure wall brick.

24 73D0024