Honeywell Complete Guide to Vista 10P and Vista 10 Programming for Home Security Systems

Mechanics of Programming

Data Field Programming Procedures (You must use a 2-line Alpha display keypad)

Task	Procedure
Entering Program Mode	A) Press both [∗] and [#] at the same time within 50 seconds after power is applied
	to the control, OR
	B) After power-up, enter [Installer code (4-1-1-2)] + 8 0 0.
	(method “B” is disabled if you exit the program mode using ∗98)
Go to a Data Field	Press [∗] + [Field Number] (for example, ∗21).
	A display of “EE” or “Entry Error” means you have entered a nonexistent field.
	Simply re-enter [∗] plus a valid field number.
Entering Data	When the desired field number appears, simply enter the digits required. The
	keypad beeps three times after the last digit is entered and automatically displays
	the next data field in sequence.
	If entering less than the maximum digits available (e.g., phone number field),
	enter the desired digits, then press [∗] to end the entry.
Review a Data Field	Press [#] + [Field Number]. Field data is displayed, but no changes can be made.
Deleting an Entry	Press [∗] + [Field No.] + [∗] (applies only to phone number, account number, and
	pager character fields).

Menu Mode Programming (∗56, *57, ∗58, ∗79, ∗80, ∗81, ∗82)

Entering Menu Mode	Press [∗] + [Menu Mode No.] (for example, ∗56) while in Program Mode. The
	Alpha display keypad displays the first of a series of prompts.
	After making the appropriate entry, press the [∗] key to accept the entry and
	continue to the next prompt.

Loading Factory Defaults/Initializing for Download

To Load Default Entries	Press ∗97 while in Program Mode. This resets all data fields to the default
	values shown on the Program Form. Use ∗97 only if you wish to return to the
	original factory-programmed defaults. Do not press ∗97 to load defaults if any
	programming has been done previously—data already programmed into the
	system will be changed!
To Initialize Download ID	Press ∗96 while in Program Mode. This initializes the system for
	downloading and resets all the subscriber account numbers and CSID.

Exiting the Programming Mode

Prevent installer code reentry	Press ∗98. Exits Programming Mode and prevents re-entry by:
	Installer Code + [8] + [0] + [0]. To enter the programming mode if ∗ 98 was
	used to exit, you must first power the system down. Then power up again,
	and press [∗] and [#] at the same time, within 50 seconds of powering up.
	See field *88 for other Program mode lockout options.
Allow installer code reentry	Press ∗99. Exits Program Mode and allows re-entry by method A or B above.

3-5