Honeywell VISTA-10PSIA Programming Overview, About Programming, Keypads, To enable keypads

S E C T I O N 3

Programming Overview

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

About Programming

You can program the system at any time, even at the installer's premises prior to the actual installation. Programming can also be performed remotely from the installer’s office/home, using an IBM personal computer, a modem, and Compass downloading software.

The following is a list of the various Programming modes used to program this system:

Programming Mode…		Used to …
Data Field Programming		Program basic data fields used for setting the various system options.
		Most of the data fields in this system have been programmed for specific
		default values. However, some fields must be programmed for each particular
		installation to establish its specific alarm and reporting features.
∗56 Zone Programming		Assign zone characteristics, report codes, alpha descriptors, and serial
		numbers for 5800 RF transmitters.
∗57 Function Key Programming		Program each of the four alphabet function keys to perform one of several
		system operations.
∗58 Zone Programming		Assign zone attributes similar to ∗56 mode, but provides a faster
(Expert Mode)		programming procedure and is intended for those more experienced in
		programming controls of this type.
∗79	Output Device Mapping	Assign device address of the 4204 Relay module and map the specific relays
∗80	Output Definitions	Define up to 12 output definitions which can control the output relays mapped
		using *79 Output Device Mapping mode.
∗81	Zone List Programming	Create Zone Lists for relay zones, chime, night-stay, cross zones, and pager
		zones.
∗82	Alpha Programming	Create alpha descriptors for easy zone identification.
Scheduling Mode (code + [#] +64)		Create schedules to automate various system functions.

Keypads

Keypads are identified by predefined addresses (starting at address 16) as follows:

Address	Keypad	Program Field
16	keypad 1	• always enabled, all sounds enabled.	NOTE: First keypad is address 16.
17	keypad 2	• data field *190
18	keypad 3	• data field *191
19	keypad 4	• data field *192
20	keypad 5	• data field *193
21	keypad 6	• data field *194
22	keypad 7	• data field *195
23	keypad 8	• data field *196

To enable keypads:

1.Set desired address at keypad (refer to keypad’s instructions for setting the address).

2.Use data field program mode to enable keypad addresses and enable sound options in fields *190- *196 as shown in the table above.

3.Set the following keypad-related data fields as required by the installation: *21 Quick Arm Enable; *23 Forced Bypass; *84 Auto STAY Arm

3-1