Configuration using the PC |
Auto Ack
If enabled for the group using this directory, the Auto Ack command causes the Cv2 to automatically acknowledge its alarms without receipt of any other code or signal. This command is used when it is anticipated that the called party will have no means of acknowledging the call. Unless absolutely necessary, this command should not be used since there is no assurance that the alarm message was properly received.
The Auto Ack command should be the last entry in the directory and must appear on a line by itself.
DTMF
The DTMF command will result in the string of DTMF digits in the associated Value field being transmitted. The maximum length of the DTMF string is 39 characters and the characters can be any of the 16 digits including A, B, C, and D. The special character ‘!’ can be inserted anywhere in the DTMF string to create a two second delay.
DTMF must be preceded by a Dial command; it cannot be the first entry in the list. It can be used more than once in a list.
Default DTMF value: 0000
Alert
The Alert command generates a tone sequence that is used to alert the called party that a message will follow. The tone sequence consists of eight 100 msec bursts of 1 kHz tone separated by 100 msec of quiet.
Alert must be preceded by a Dial command; it cannot be the first entry in the list. It can be used more than once in a list.
Voice
The Voice command causes stored voice messages for the Site ID, Group IDs and any points in the alarm state to be spoken. If Voice is the only command after Dial, the Cv2 will speak the alarm message three times or for one minute, whichever comes first. If other commands are used, either before or after Voice, the messages will be spoken once.
Voice must be preceded by a Dial command; it cannot be the first entry in the list. It can be used only once in a list.
Answer
The Answer command causes the Cv2 to monitor the called line for activity before it begins to speak the alarm message. If the Cv2 is calling a voice or numeric paging terminal with an automated attendant, the Answer command will cause it to wait for the voice prompt before transmitting the pager number. Do not place the Answer command immediately after a Dial command if Call Progress is selected in the General section. This will cause the Cv2 to look for a voice response twice in a row and may prevent alarm announcements.
B1272M001 | BARNETT ENGINEERING LTD. | ProTalk Cv2 |