Linear DVS-2400 manual Communicator Reporting Options, Reporting Format, Call Routing

COMMUNICATOR REPORTING OPTIONS

REPORTING FORMAT

✦The factory setting causes the communicator to report using the 4 BY 2 FORMAT. This format allows four-digit account numbers from 0000 to 9999 and provides two-digit alarm codes.

STEP #105 ADEMCO CONTACT ID can be chosen as a reporting format using this step. This format allows 4-digit account numbers from 0000 to 9999 and provides verbose report descriptions with Ademco Contact ID compatible Central Stations.

1

0PROGRAMMING STEP #105

5JKL

PROGRAM

HOME

0 FOR 4 BY 2

1 FOR ADEMCO CONTACT ID

AWAY

STORE PROGRAM

CALL ROUTING

✦The communicator can be programmed with three telephone numbers; primary, secondary, and supervisory.

✦The factory setting for the communicator is to route all calls to the primary telephone number. If communication is unsuccessful after five attempts to the primary number, the secondary number will be dialed for an additional five attempts. If the secondary number cannot be reached, the communicator will “sleep” for five minutes before starting the call process over again. A total of four sleep cycles (50 call attempts) can occur before the communicator stops calling.

8TUV

6MNO

HOME

AWAY

PROGRAMMING STEP #86

PROGRAM

0 FOR ALL TO PRIMARY/SECONDARY 1 FOR ALARMS ONLY TO

PRIMARY/SECONDARY

STORE PROGRAM

STEP #86 The communicator can be programmed to report supervisory events (low battery, trouble, AC failure, etc.) to the supervisory telephone number instead of the primary or secondary telephone numbers using this step.

✎CAUTION: If the page alert user code feature is going to be used, the supervisory number is reserved for the pager number. DO NOT SET THE CALL ROUTING OPTION TO “1”.

✎NOTE: To disable supervisory reports, set call routing option to “1” and remove the supervisory telephone number.

✎NOTE: Do not program the primary and secondary telephone numbers the same. See the FCC Telephone Rules and Regulations on the rear cover of this manual.

COMMUNICATOR REPORTING OPTIONS

STEP	PROGRAMMING			POSSIBLE	FACTORY	INSTALLATION
#	FUNCTION			VALUES	VALUE	VALUE
			0	= ALL CALLS TO PRIMARY OR SECONDARY NUMBER	0
86	CALL ROUTING		1	= ALL ALARM CALLS TO PRIMARY OR SECONDARY NUMBER AND ALL
			OTHERS TO SUPERVISORY NUMBER
88	ACCOUNT NUMBER		4 DIGITS		EMPTY
89	PRIMARY PHONE NUMBER		UP TO 20 DIGITS		EMPTY
90	SECONDARY PHONE NUMBER		UP TO 20 DIGITS		EMPTY
91	SUPERVISORY/PAGER PHONE NUMBER		UP TO 20 DIGITS		EMPTY
			PRESSING THE (A) KEY INSERTS A 1-SECOND DELAY
		⇒ ⇒ ⇒	THE [FIRE] KEY INSERTS A 5-SECOND DELAY
	FOR ALL PHONE NUMBERS		THE [CHIME] KEY INSERTS A “*”
			THE (A) KEY INSERTS A “#” IF IT IS THE LAST DIGIT OF THE PHONE NUMBER
105	REPORTING FORMAT		0	= 4 BY 2; 1 = ADEMCO	0
108	REPORT SYSTEM TROUBLE		0	= NO; 1 = YES	0
110	REPORT FORCE ARMING		0	= NO; 1 = YES	0
111	OPEN/CLOSE		0	= NO; 1 = YES; 2 = MASTER PAC ONLY	0
113	POINT ID REPORTING FOR 4 BY 2 FORMAT		0	= NO; 1 = YES	1

Communicator Reporting Option Table

35