Linear DVS-2400 manual Type 2AG, 1-ampfuse

Page 9
11

11

10

22

13

12

21

20

14

15

16

 

 

 

17

18

19

10AUXILIARY FUSE

Type 2AG, 1-amp fuse.

Protects the external relay output when used with wet contacts (12 VDC switched out).

Fuse will blow when load exceeds 1 amp.

WARNING: For continued protection against the risk of fire, replace only with the same type and rating of fuse.

11MAIN TERMINAL BLOCK

Terminals for connection to the plug-in AC transformer.

Terminals for connection to an external siren speaker.

Automation Output to connect to an automation controller.

External relay output for “wet” contacts (switched 12 volts) or “dry” contacts (normally open 1 amp @ 24 volts maximum).

12BATTERY FUSE

Type 2AG, 3-amp fuse for the backup battery.

If the POWER light is fl ashing and the optional backup battery is installed and charged, check this fuse.

WARNING: For continued protection against the risk of fire, replace only with the same type and rating of fuse.

13TELEPHONE TERMINAL BLOCK

Provides telephone connections for the digital communicator.

Provides telephone connection for voice prompted telephone remote control (optional VB-2 digital voice response module required).

Provides seized ring and tip connections for local telephone instruments. Communicator will disconnect local telephones while on-line.

14INTERNAL SPEAKER CONNECTOR

Connects the internal speaker to the Console circuit board.

2-pin connector, non-polarized.

15ANTENNA TERMINALS

Antenna and ground terminals for receiving signals from the system's sensors.

Pre-wired to the Console's internal wire dipole antenna.

Alternately connects to the Model LA-P local whip and remote antenna kit.

16OPTIONAL BACKUP BATTERY

Space for 12-volt, 1.2 amp/hour backup battery. (Highly recommended.)

Backup battery is automatically charged and monitored by the Console.

Backup battery can power the Console for up to 6 hours.

UL NOTE: Normal estimated battery life should be 3 to 4 years.

17WIRING ACCESS HOLE

Provides access to recessed wiring trough in base of Console.

Route cables for power, telephone, external speaker, etc. through this hole.

Loop for zip-tie strain relief provided next to hole.

18WALL-MOUNT SLOTS

Used when mounting Console recessed in the wall.

Two mounting brackets (supplied) slide through slots and are retained by screws, clamping the unit to the wall.

19RADIO TEST POINTS

Used to monitor the Console's radio receiver during troubleshooting.

Provides connection for an audio amplifi er to listen to the receiver's output.

Helpful to determine sources of radio interference.

20MICROPHONE (WITH MODEL VB-2 INSTALLED ONLY)

High sensitivity microphone.

Detects room audio when communicator is reporting to the Central Station in 2-way audio mode (Model VB-2 digital voice synthesis module must be installed).

21ANNUNCIATOR VOLUME CONTROL

Varies the volume of the advisory tones that come from the speaker.

Does not affect internal or external sirens (they are always full volume).

22DIGITAL VOICE SYNTHESIS MODULE (OPTIONAL)

The Model VB-2 gives the Consoles's digital communicator listen-only, manual 2-way and full duplex 2-way audio capability with the Central Station.

The module allows remote command of the system using a standard pushbutton telephone, on or off site.

The module provides optional voice prompts from the Console’s speaker.

Units programmed for two-way duplex can still be controlled manually by pressing the “1” or “3” key.

The Central Station can now return the unit to two-way duplex by pressing the “8” key.

7

Image 9
Contents Installation & Programming Instructions SUPERVISED WIRELESS SECURITY CONSOLESECURITY USA & CanadaINTRODUCTION This symbol is for important notesTABLE OF CONTENTS CONSOLE 1.THE DVS-2400SECURITY SYSTEMREMOTE CONTROLS WIRELESS KEYPADDOOR/WINDOW SENSORS SMOKE DETECTOR2.SECURITY SYSTEM FLOOR PLAN DESIGN THE INSTALLATIONEXAMPLE SYSTEM Example Residential Security System Floor PlanDOOR/WINDOW SENSOR 3.TYPICAL SYSTEM SENSORSABOUT SENSOR STATUS SUPERVISION WIRELESS KEYPAD5 4 3 4.CONSOLE FEATURESSwitching to Off Mode stops the alarm siren Switching to Chime Mode stops the alarm sirenType 2AG, 1-ampfuse CONSOLE LOCATION 5.CONSOLE INSTALLATIONCASE LOCKING SCREW WALL MOUNTINGEXTERNAL CONSOLE SPEAKER CONNECTION EXTERNAL ALARM SIREN CONNECTIONcan talk to the occupants through the external TELEPHONE LINE CONNECTION AUTOMATION OUTPUT CONNECTION OPTIONALConnect the Console to the telephone line if the not plug the transformer in until the wiring is CONSOLE POWER CONNECTIONBACKUP BATTERY INSTALLATION OPTIONAL complete6.BASIC CONSOLE PROGRAMMING indicator for that sensor will stay litSTART IN TEST MASTER USER CODE 1 GONG & 5 BEEPSFollow the instructions on the previous page to PROGRAMMING DIFFERENT SENSOR TYPESselect a sensor number to program the sensor into For DXT-61, DXT-21, DXS-21, DXT-41,& DXS-62ADXS-10WIRELESS KEYPAD 7.BASIC SENSOR INSTALLATIONDXS-31& DXS-32DOOR/WINDOW SENSORS TEST SENSORS4.Snap sensor onto mounting plate LABELING THE SENSORS 8.CUSTOMIZING THE CONSOLEcaused the alarm will fl ash and stops any alarms in progress9.CONSOLE OPERATING MODES OFF MODESECURE EXIT HOME MODESTART IN OFF OR CHIME MODE START IN HOME MODEQUICK ARM AWAY MODEOPTIONAL YOUR USER CODE 1 GONG & 3 BEEPS START HERE HOLDstatus indicators 3 beeps being the strongest signalTEST MODE START IN OFF10.SYSTEM TROUBLE INDICATIONS CONSOLE LOW BATTERYSENSOR LOW BATTERIES SENSOR RADIO TROUBLE11.CUSTOMIZING THE SYSTEM and the sensor status indicator will turn offACTIVATE SENSOR DONE START IN TEST MASTER USER CODE 1 GONG & 5 BEEPS SENSOR8 FOR 8 TUV CHIME ZONE AWAY 1 BING DONE SENSOR NUMBER FOR CHIMESENSOR NUMBER FOR INTERIOR 7 FOR 7 PRS INTERIOR ZONE AWAY 1 BING DONENEW FUNCTION NUMBER FOR SENSOR AWAY 1 BING DONE SENSOR NUMBER FOR FUNCTION CHANGEMAKING A SENSOR PERFORM A DIFFERENT FUNCTION AWAY12.ADVANCED PROGRAMMING SETUP MODEHOME = PROGRAM TEST = REMOVECHANGING A SENSORS SUPERVISION CHANGING A SENSORS RESTORE REQUIREMENTSENTRY DELAY TIME EXIT DELAY TIMEREMOTE CONTROL DISARMING LEVEL REMOTE CONTROL ARMING LEVELFIRE SIREN TIME AUTOMATION OUTPUT TIMESILENT EMERGENCY ALARMS SILENT BURGLARY ALARMSDISABLING QUICK ARMING AUTOMATIC RESTORAL OF BYPASSED SENSORSREMOTE CONTROL ARM/DISARM CHIRP AUTOMATION OUTPUT MODE DURING ALARMAUTOMATION OUTPUT ON DURING AND AFTER ALARM AUTOMATION OUTPUT ON DURING ALARMAUTOMATION OUTPUT WHILE ARMED REMOTE ACCESS PASSWORDAUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS AUTOMATION OUTPUT POLARITYusing these steps. The master user code can be Because access to programming would be impossiblechanged using programming STEP #99 CONSOLE MASTER RESET13.COMMUNICATOR PROGRAMMING SETUP MODEGeneral Communicator Programming Table SETUP MODEGENERAL COMMUNICATOR OPTIONS COMMUNICATOR ENABLE2-WAYAUDIO VOICE RESPONSEDIALING DELAY CALL LIMITERDIALING METHOD 0PROGRAMMING STEP #101REPORTING FORMAT COMMUNICATOR REPORTING OPTIONSCALL ROUTING Communicator Reporting Option TablePRIMARY TELEPHONE NUMBER ACCOUNT NUMBERSECONDARY TELEPHONE NUMBER SUPERVISORY OR PAGER TELEPHONE NUMBERREPORT FORCE ARMING REPORT CONSOLE TROUBLEOPENING AND CLOSING REPORTS POINT ID REPORTINGGENERAL REPORTING CODES COMMUNICATOR REPORTING CODESSTEPS #201-206 General Reporting Codes TableSTEPS #261-266 SYSTEM REPORTING CODESFORCE ARMING REPORTING CODE DURESS REPORTING CODE4 BY 2 FORMAT POINT ID REPORTING CODES 4 BY 2 FORMAT POINT ID ALARM REPORT CODESSTEPS #210-233 4 BY 2 FORMAT POINT ID TROUBLE REPORT CODES4 BY 2 FORMAT POINT ID REPORTING CODES 4 by 2 Format Point ID Reporting Code TableSTEP # PROGRAMMING FUNCTIONWIRELESS PRODUCT NOTICE LINEAR LIMITED WARRANTY14. IMPORTANT INFORMATION FCC NOTICE
Related manuals
Manual 48 pages 58.1 Kb

DVS-2400 specifications

The Linear DVS-1200, DVS-2400, RA-2400, DUAL-824, and DVS-2408 are advanced digital video surveillance systems designed for a variety of security applications. These models offer state-of-the-art features, technologies, and characteristics that enhance security monitoring and recording capabilities.

The DVS-1200 is a compact and efficient digital video recorder that supports up to 12 channels of video input. It features high-resolution recording capabilities, providing clear and detailed images. With real-time playback and advanced motion detection, the DVS-1200 allows users to monitor activities effectively. Its user-friendly interface simplifies configuration and operation, making it accessible for both novice and experienced users.

Upgraded for larger installations, the DVS-2400 supports up to 24 channels. This model is equipped with H.264 video compression technology, significantly reducing storage requirements while maintaining high-quality images. The DVS-2400 also offers remote access capabilities, enabling users to view live footage or playback recorded events from anywhere using a smartphone or computer. Its built-in analytics features allow for motion detection, line crossing alerts, and more, enhancing overall security.

The RA-2400 is a remarkable model designed for robust performance in demanding environments. This recorder not only supports 24 channels but also integrates advanced RAID technology for data redundancy and enhanced storage reliability. The RA-2400 is ideal for applications where data loss is unacceptable, making it suitable for critical infrastructure and high-security locations.

The DUAL-824 model stands out with its unique dual-stream encoding feature. It allows simultaneous recording and streaming of two video resolutions, providing flexibility for different applications such as local monitoring and remote access. This model supports up to 8 channels and is equipped with advanced event triggers, ensuring significant activities do not go unnoticed.

Finally, the DVS-2408 is a versatile and high-performance system designed for larger facilities. With support for 24 channels and the ability to integrate with various IP cameras, the DVS-2408 delivers exceptional scalability. This model comes with comprehensive software for monitoring and management, allowing for multiple users and custom user permissions.

Together, these Linear video surveillance models represent a robust and reliable solution for modern security needs, featuring the latest technologies and high-quality performance to ensure safety and peace of mind in various environments.