Hornet Car Security 700T manual H1/2 WHITE light flash output

Page 13

H1/2 WHITE light flash output

H1/2 WHITE light flash output

As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper inside the unit is moved to the opposite position (see the Internal Jumpers section of this guide), this wire supplies a (-) 200 mA output. This is suitable for driving (-) parking light wires.

H1/3 WHITE/BLUE (+) trunk release/sensor shunt input

This input is used to bypass sensor inputs when the trunk is opened using the factory transmitter. Connect this wire to the (+) trunk release output of the factory keyless entry system or trunk release relay. When the system receives a (+) input on this wire, zones 2 and 4 are bypassed for three seconds. If during that three seconds, ground is applied to the H1/6 BLUE wire zones 2 and 4 will remain bypassed until the ground input is removed. This means that when the trunk is opened with the factory transmitter the only triggers that remains active while the trunk is open are the doors. Three seconds after the trunk is closed the bypassed zones will become active again.

© 2001 Directed Electronics, Inc. Vista, CA

13

Image 13

Contents Model 700T Installation Guide2001 Directed Electronics, Inc. Vista, CA N700T Rev. E Auxiliary Harness H2 Wire Connection Guide table of contentsSystem Features Learn Routine Wiring Quick Reference Guideinstallation points to remember what is includeddeciding on component locations tools requiredcontrol module valet/program switchoptional starter kill relay status LEDfinding the 12V switched ignition wire finding the wires you needobtaining constant finding a + parking light wire finding the starter wire finding the door pinswitch circuitsolderless butt connections making your connectionssolder connections IMPORTANT! Never interrupt any wire other than the starter wire primary harness H1 wire connection guideH1/1 H1/2H1/3 WHITE/BLUE + trunk release/sensor shunt input H1/2 WHITE light flash outputConnect this wire to the optional domelight supervision relay H1/8 BLACK - chassis ground connection H1/7 VIOLET + door trigger inputH1/9 YELLOW + ignition input the same point you connect the control module’s black ground wire H2/1 BROWN - horn honk output auxiliary harness H2 wire connection guideH2/2 GREEN arm input H2/3 RED disarm defeat inputDriver’s Unlock LockPassenger Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine on-board stinger doubleguard shock sensor plug-in harnesseslight flash jumper internal programming jumpersystem features learn routine TWO CHIRPS - PRESS system features menu8 NO FUNCTION table of zones troubleshootingrapid resume logic Shock sensor does not trigger the alarmClosing the door triggers the system, but opening the door does not The Valet/program switch does not workStatus LED does not work wiring quick reference guide