Hornet Car Security 700T manual internal programming jumper, light flash jumper

Page 22

internal programming jumper

internal programming jumper

light flash jumper

This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and the unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-board relay is disabled. The WHITE wire, H1/2, will supply a (-) 200 mA output suitable for driving factory parking light relays. To access the jumper, remove the sliding door from on top of the control module.

22	© 2001 Directed Electronics, Inc. Vista, CA

Image 22

Contents Model 700T Installation Guide2001 Directed Electronics, Inc. Vista, CA N700T Rev. E System Features Learn Routine table of contentsAuxiliary Harness H2 Wire Connection Guide Wiring Quick Reference Guidewhat is included installation points to remembertools required deciding on component locationsvalet/program switch control modulestatus LED optional starter kill relayfinding the 12V switched ignition wire finding the wires you needobtaining constant finding a + parking light wire finding the door pinswitch circuit finding the starter wiremaking your connections solderless butt connectionssolder connections H1/1 primary harness H1 wire connection guideIMPORTANT! Never interrupt any wire other than the starter wire H1/2H1/2 WHITE light flash output H1/3 WHITE/BLUE + trunk release/sensor shunt inputConnect this wire to the optional domelight supervision relay H1/8 BLACK - chassis ground connection H1/7 VIOLET + door trigger inputH1/9 YELLOW + ignition input the same point you connect the control module’s black ground wire H2/2 GREEN arm input auxiliary harness H2 wire connection guideH2/1 BROWN - horn honk output H2/3 RED disarm defeat inputDriver’s Unlock LockPassenger Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine plug-in harnesses on-board stinger doubleguard shock sensorinternal programming jumper light flash jumpersystem features learn routine system features menu TWO CHIRPS - PRESS8 NO FUNCTION rapid resume logic troubleshootingtable of zones Shock sensor does not trigger the alarmClosing the door triggers the system, but opening the door does not The Valet/program switch does not workStatus LED does not work wiring quick reference guide