What is included

■One control module with on-board shock sensor

■One plug-in status LED

■One plug-in Valet/program switch

■One 12-pin primary harness (H1)

■One 5-pin auxiliary harness (H2)

■One Revenger Soft-Chirp siren

installation points to remember

before beginning the installation

■Check with the customer on Status LED location.

■Use seat and fender covers to protect the vehicle.

■Remove the domelight fuse. This prevents accidentally draining the battery.

■Roll down a window to avoid being locked out of the car.

■Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped with an air bag, avoid disconnecting the battery if possible.

■Remove necessary under-dash trim panels to provide access for mounting the system’s components.

IMPORTANT! Please read this entire installation guide before beginning the installation. The instal- lation of this security system requires interfacing with many of the vehicle’s systems. Many new vehicles use low-voltage or multiplexed systems which can be damaged by low resistance testing devices, such as test lights or logic probes. Test all circuits with a high-quality digital multi-meter before making the connections.

IMPORTANT! Many airbag systems display a diagnostic code through their warning light after they lose power. Disconnecting the battery requires this code to be erased, which can require a trip to the dealer.

after the installation

■Test all functions. The “Using Your System” section of the Owner’s Guide is very helpful when testing.

■When testing, don’t forget that this system is equipped with Nuisance Prevention Circuitry (NPC). This cir- cuitry can bypass both instant trigger zones, making them appear not to work.

■Carefully reassemble the under-dash trim panels.

■Inspect the engine compartment for tools that may have been left behind.